NEUTRIK Easycon EZ Series User manual

EZ SeriesEasycon
XLR Cable Connector
IDC - Version
- First slide the housing onto the cable.
- Slide the prepared end of the cable into
the contact holes.
- Position the cable in the insert so that
the shield is between the ground contact
and the jacket.
- Hold cable and insert in this position and
put the cable retention element onto the
insert .
- Press the cable retention down to the
base part until it snaps in.
- Strip cable jacket and wires according
to figure.
- Twist the shielding strands and bend
the shield back over the jacket.
15
15
2.
1.
SNAP
1
Male
#3
#2
1
Female
#2
#3
Assembly Instructions

Disassembly:
Data subject to change without prior notice.
9/99 : 3102M0751
.1999 NEUTRIK ALL RIGHTS RESERVED.

- Push the complete insert into the housing as shown (pay attention to the currect radial
position).
Female connector:
Press down the latching spring befor entering the housing.
NOTE
The assembly is finished when:
Female: - The insert has snapped into the housing and the latch has returned to its
orginal position.
Male: - The insert has snapped into the housing.
Female: - Press the latching and the mating face completely down.
- Push the insert with the cable out of the housing.
Male: - Press the mating face completely down and push the insert with the cable out
of the housing.
NEUTRIK AG NEUTRIK (UK) Ltd. NEUTRIK Tokyo Ltd.NEUTRIK Zürich AG NEUTRIK USA INC. NEUTRIK HGK
www.neutrik.com
Liechtenstein Great Britain JapanSwitzerland USA Hong Kong
Tel.: [phone] Tel.: [phone] Tel.: [phone] T
Fax: [phone] Fax: [phone] Fax: [phone]
Tel.: [phone] el.: +1 732/901 9488 Tel.: [phone]
Fax: [phone] Fax: [phone] Fax: [phone]
SNAP IN SNAP IN