NEUTRIK NP3TT-P User manual

First slide the plug’s plastic cover onto the cable as
shown in figure 1.
Pay close attention that the cover’s locking tooth
labelled faces the end of the cable, where the plug
Will be connected.
A
Prepare the cable by stripping away 15 mm of the
outer cable jacket.
Reduce the shielding strands to a length of 7 mm
and bend them over the jacket.
Shorten the wire, which will connect to the tip, to a
length of 10 mm.
Strip away 4 mm of the jacketing of each wire as
indicated in figure 2.
Slide the prepared end of the cable into the open end
of the plug, so that 9 mm of unstripped cable rests
inside the plug behind the prepared end.
Heat the ring terminal labelled with a soldering bit,
then position the longer wire on the heated terminal
and allow solder to melt affixing the wire to the
terminal. Repeat the process with the tip terminal
labelled in figure 4 with the shorter wire.
B
C
figure 1
figure 2
figure 3
figure 4
A
C
B
NP3TT-P
0.173” (4.4 mm) BANTAM-TYPE MINIATURE PLUGS
Assembly Instructions
4
7
15
10
4

Next crimp the end of the plug containing the cable
with a standard 5.41 mm hexagonal crimping Tool
(RG 58).
Crimp only in the area designated in figure 5!
Finish the installation sliding the cover over the plug,
so that the cover’s locking tooth rests in the plug’s
notch labelled displayed in figure 6.D
figure 5
figure 6
Position a screw driver into one of the two tiny slots
as shown in figure 1 and bend out the plastic snap.
Slide the plastic cover from the connector.
figure 1
figure 2
D
Disassembly:
D
Data subject to change without prior notice. 2003 NEUTRIK . ALL RIGHTS RESERVED.©®
R
N E U T I K R
R
CONNECTING THE WORLD
NEUTRIK AG NEUTRIK Zürich AG NEUTRIK (UK) Ltd. NEUTRIK USA INC. NEUTRIK Tokyo Ltd. NEUTRIK France NEUTRIK Vertriebs GmbH
Liechtenstein Great BritainSwitzerland USA Japan France Germany / Netherlands
Tel.: [phone] Tel.: [phone] Tel.: [phone] Tel.: [phone] Tel.: [phone] Tel.: [phone] Tel.: [phone]
Fax: [phone] Fax: [phone] Fax: [phone] Fax: [phone] Fax: [phone] Fax: [phone] Fax: [phone]
www.neutrik.com
Draft. Nr.: BDA 034
Update:
/3102M0531
21.10. 2003