NEUTRIK opticalCON NO2-4FDW-A User manual

opticalCON |
NO2-4FDW-A Soldering Instruction
R
Page 1
HANDLING INSTRUCTION
Strip all 4 copper cords at a length of
3 mm, while using the baring tool.
Slide the prepared shrink tube with a length
of 10 mm over copper cord (pin 1 and 4).
Pre-solder tip of the copper cords for
enhanced heat transfer.
ATTENTION! Don’t use too much solder.
3
A
B
Cable Preparation
C
A. HANDLING INSTRUCTION

opticalCON - Handling Instruction NO2-4FDW-A
I
Draft. Nr.: BDA 360 / 3102M2141 Update: 03.02.2014
I I Data subject to change without prior notice. 2014 NEUTRIK . ALL RIGHTS RESERVED. NEUTRIK are registered trademark.
® ®
©
www.neutrik.comwww.neutrik.com
R
NEUTRIK AG LI T: +423 /237 24 24 F: +423 /232 53 93
NEUTRIK USA Inc. USA T: +1 704 /972 3050 F: +1 704 /438 9202
( )
NEUTRIK UK Ltd. UK T: +44 1983 /811 441 F: +44 1983 /811 439
NEUTRIK Vertriebs GmbH DE /NL /AT/DK T: +49 8131 /280 890 F: +49 8131 /280 830
NEUTRIK France FR T: +33 1 / 4131 6750 F: +33 1 / 4131 0511
NEUTRIK Tokyo Ltd. JP T: +81 3 / 3663 4733 F: +81 3 / 3663 4796
NEUTRIK Hong Kong Ltd. HK T: +852 / 2687 6055 F: +852 / 2687 6052
Page 2
Insert pre tinned copper cords into the
terminals and solder them on.
Attention: Do not use too much solder.
Avoid cold solder joints!
Slide heat shrink over solder joint and shrink
it with a hot air gun.
Attention: Set appropriate temperature
according used wires and shrink tube.
HOT AIR
GUN
Cable Soldering
D
E
Cable Shrinking
Solder cups completely
covered with heat shrink.
No “cold” solder joints.
B. Finished Product