Noble House Home Furnishings Bar Chair User manual

Part NO. Picture Description QTY
A Chair Back 1
Caution: You must read this before you proceed.
Bar Chair
Noble house Home Furnishings LLC Page 1 OF 6

B Chair Leg 4
C Side Rail 4
Label Picture Description QTY
①Bolt (M8x50mm) 9
②Screw (M4x40mm) 9
③Spring Washer 9
④Washer 9
⑤Allen Key 1
⑥Screwdriver 1
For assembling
Chair Legs(B) to the Chair
Back(A)
Bolt (M8x50mm)
Washer
Spring Washer
Allen Key
Before Beginning Assembly:
Noble house Home Furnishings LLC Page 2 OF 6

For assembling
Side Rails(C) to Chair
Legs(B)
Screw (M4x40mm)
This Bar Chair has multiple parts and may require up to 30 minutes to assemble. To give you an
overview of the Bar Chair parts, the above picture is to help you put the various Bar Chair parts
into perspective. Please read through the instructions below to familiarise yourself with the parts
and steps before assembly.
Step 1
Unpack and Place the Chair Back(A), Chair Legs(B) and Side Rails(C) on a clean, non-marring surface.
Chair Frame (A)
Chair Leg (B)
Side Rail (C)
Chair Back (A)
Chair Leg (B)
Side Rail (C)
Noble house Home Furnishings LLC Page 3 OF 6

Step 2
Place the Chair Back(A) onto the side of a table as shown in the picture.
Insert the Chair Legs(B) into the base of Chair Back(A).
Attach Chair Legs(B) to Chair Back(A) using Bolts(①), Spring Washers(③), and Washers(④) with Allen Key(⑤)
Do not fully tigthen Bolts.
Step 3
Insert Side Rails(C) between Chair Legs(B) in the sequence: (C-1), (C-2), (C-3), (C-4), as shown above.
Note: You may need to apply a little pressure to the Chair Legs to enable the Side Rails to be slotted into
position.
Attach Side Rails(C) to Chair Legs(B) using Screws(②) with Screwdriver(⑥).
Do not fully tighten the Screws.
5
3
4
1
A
BBB
BB
6
2
2 C
C-1 C-2
C-3
C-4
Noble house Home Furnishings LLC Page 4 OF 6

Place the Bar Chair on a LEVEL SURFACE to see if it wobbles.
If it wobbles, lift the Bar Chair to some 30cm to 50cm high from the ground.
Keep your feet and toes well away from the drop zone.
Drop the Bar Chair freely and vertically with the four legs, hitting the ground, at the same time.
This Drop Test will help to ensure that all the Bolts, Screws and gaps reach full alignment status.
Test again for evenness on a LEVEL SURFACE.
If no wobbles found, proceed to tighten all the Bolts and Screws.
When tightening the Bolts and Screws, tighten sequentially.
DO NOT tighten any Bolt or Screw fully and then move on towards the next one.
This would cause the frame to warp.
If there are still wobbles, loosen the Bolts and Screws and execute this same drop test.
Step 5
Your Bar Chair is now ready for use.
This Bar Chair can only be used on a flat, level surface.
Step 4
5A
B
Noble house Home Furnishings LLC Page 5 OF 6

Noble house Home Furnishings LLC Page 6 OF 6