NRS Healthcare Mowbray Lite M66613 User manual

1
USER INSTRUCTIONS
MOWBRAY LITE FLAT PACK
TOILET FRAME AND SEAT
M66613 Mowbray Lite Flat Pack - Height & Width Adjustable
General Safety Warning
Please make sure that you read and follow these
instructions carefully. Keep these instructions in a
safe place for future reference.
Maximum User Weight
30st
190kg
1. INTENDED USE
To assist those who have di󰀩culty in lowering onto or rising from a standard toilet. The comfortable plastic moulded
seat o󰀨ers support in a natural position. An optional oor xing kit is also available (F11572).
2. SAFETY
WARNING: The maximum user weight must not be more
than 190 kg (30 st).
DO NOT: Attempt to stand or climb on the product.
MAKE SURE: All legs are set at equal height to avoid
rocking.
3. UNPACKING
Remove the packaging and check all parts carefully.
Contact your supplier immediately if parts are missing or
damaged and do not try and assemble.
3.1 Contents:
1. Toilet Seat x 1
2. RH Frame Assembly x 1
3. LH Frame Assembly x 1
4. Crossbars x 2
5. Leg Extensions x 4
6. E-clips x 8
4. ASSEMBLY
4.1 Fitting the Crossbars
1. Slot the 2 x crossbars onto the side-frame assemblies
and adjust to the correct width for the toilet and the
user.
2. Align the holes and secure with the 4 x E-clips.
Note: Make sure that the side-frames and crossbars
have been set to the same width/adjustment holes.
4.2 Fitting the Leg Extensions
3. Slot the 4 x leg extensions into the side-frame
assemblies and adjust to the correct height for the
toilet and the user.
4. Align the holes and secure with the 4 x E-clips.
Note: Make sure the leg extensions have all been set to
the same height.
4.3 Fitting the Seat
5. Remove the seat from the bag and snap into place
on the centre bars of the frame.

2
5. INSTALLATION
1. Lift the toilet seat and lid.
2. Put the Mowbray seat over the toilet with the cutaway
of the seat at the front and the integral splash guard
placed centrally over the toilet bowl.
Note: Make sure the seat and toilet frame are fully secure
before use.
6. IN USE
6.1 Adjust the Height
1. Remove the 4 x leg extension E-clips.
2. Slide the leg extensions to the required height,
align the holes and replace the E-clips.
Note: Make sure the leg extensions have all been set to
the same height.
Note: Make sure the seat and toilet frame are fully secure
before use.
6.2 Adjust the Width
1. Remove the 4 x crossbar E-clips.
2. Slide the side frame assemblies to the required
width, align the holes and replace the E-clips.
Note: Make sure the side frame assemblies have been
set to the same width.
Note: Make sure the seat and toilet frame are fully secure
before use.
6.3 Fitting the Optional Floor Fixing Kit F11572
Please refer to the user instructions provided with the
optional oor xing kit.
7. MAINTENANCE
Check that all xing clips are inserted correctly and that
there is no excessive movement.
If a oor xing kit has been tted, check the xing screws
are secure.
Inspect the product regularly for signs of wear or damage,
pay particular attention to the condition of the ferrules.
Any suspected faults or damage should immediately be
reported to the supplier and the product taken out of use.
8. CLEANING INSTRUCTIONS
Please check the suitability of the cleaning products
before use. Do not use abrasive cleaners or cloths as
these could permanently damage the surface and
invalidate any warranty.
Regularly clean with a non-abrasive cleaner.
To disinfect, wipe with a dilute bleach solution, and rinse
thoroughly with fresh water.
This product is suitable for thermal decontamination and
can be steam cleaned or autoclaved on cleaning cycles
up to 70°C.
Allow product to fully dry prior to use/storage.
9. ACCESSORIES & SPARE PARTS
F11572 - Floor Fixing Kit
F17938 - Ferrule
M66820 - Seat
N43218 - E-clips x 4
For further information please visit our website or call
Customer Services on the details below.
10. PRODUCT DISPOSAL
This product should be thoroughly cleaned prior to
disposal.
This product is manufactured from metal and plastic and
can be disposed of through Local Authority Household
Waste and Recycling Centres or through Local Trade
Waste Collectors.
11. PRODUCT GUARANTEE
NRS Healthcare guarantee this product for a period of
24 months, from the date of purchase, against faulty
materials and workmanship.
This guarantee does not cover abuse, interference or
tampering with any part of the products. Issues arising
from fair wear & tear and customer misuse are not
covered.
This guarantee covers domestic use only. If the product is
used in commercial or semi-commercial settings such as
care homes, schools, rental or communal accommodation
etc, the guarantee is valid for one year only. Consumable
parts are also guaranteed for one year only.
Any guarantee issued by NRS Healthcare does not a󰀨ect
your statutory rights.

3M66613-UI-11 29-12-2023
12. GLOSSARY
Manufacturer
LOT
Batch Reference Code Consult the instructions for
use
Important Note Authorised representative in
the European Community
MD
Medical Device
REF
Item/Catalogue number European Conformity /
Conformité Européene
UK conformity assessed
marking
30st
190kg Maximum User Weight Warning
NRS HEALTHCARE Sherwood House,
Cartwright Way, Forest Business Park
Bardon Hill, Coalville, Leicestershire,
LE67 1UB, UK.
NRS HEALTHCARE 4C Altona Road,
Blaris Industrial Estate, Lisburn, Co Antrim,
Northern Ireland BT27 5QB
Tel: Customer Services: [phone] Email: [email protected]
NRS Healthcare is a leading supplier of community equipment and daily living aids.
Please visit one of our websites to view our full range of products:
www.healthcarepro.co.uk or www.completecareshop.co.uk