nvent LENTON User manual

Push pin in and through
center of coupler
Section of rebar
to be spliced
Mark Rebar
Mark Rebar
Slide
coupler
Slide
coupler
Stop Pin
Read all instructions and procedures. Ensure nVent LENTON Connect is sized properly per project plans. Refer to
product instruction sheet for coupler installation procedure details. Additional copies of instructions and
application information are available at www.nVent.com
Step 1 : Slide the coupler onto each rebar end until the rebar touches the stop pin. Mark the rebar to ensure
proper coupler/rebar engagement.
Step 2 : To allow rebar to pass entirely through the coupler, remove the stop pin by pushing the pin into the
inside diameter of sleeve. Discard the stop pin.
TECHNICAL SUPPORT:
www.nVent.com
PDF139_A
INSTRUCTION SHEET
1 of 2
nVent, nVent CADDY, nVent ERICO Cadweld, nVent ERICO Critec, nVent ERICO, nVent ERIFLEX, and nVent LENTON are registered trademarks
of nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reservers the right to change
specifications without prior notice.
WARNING:
nVent products shall be installed and used only as indicated in nVent product instruction sheets and training materials. Instruction sheets are available at www.nVent.com and from your 1.
nVent customer service representative.
nVent products must never be used for a purpose other than the purpose for which they were designed or in a manner that exceeds specified load ratings. 2.
All instructions must be completely followed to ensure proper and safe installation and performance. 3.
Improper installation, misuse, misapplication or other failure to completely follow nVent's instructions and warnings may cause product malfunction, property damage, serious bodily 4.
injury and/or death, and void your warranty.
The customer is responsible for:
a. Conformance to all governing codes.
b. The integrity of structures to which the products are attached, including their capability of safely accepting the loads imposed, as evaluated by a qualified engineer.
c. Using appropriate industry standard hardware as noted above.
SAFETY INSTRUCTIONS:
All governing codes and regulations and those required by the job site must be observed.
Always use appropriate safety equipment such as eye protection, hard hat, and gloves as appropriate to the application.

© 2019 nVent All Rights Reserved

Marked rebar completed in step 1
Slide couplerSlide coupler
Place new
section of bar
Slide coupler Slide coupler
Slide couplerSlide coupler
Place new bar
and couplers
Slide coupler Slide coupler
Marked rebar completed in step 1
OPTION A
OPTION B
Step 3A: Allow rebar to pass entirely through the coupler and align the rebar.
Step 4A: Slide coupler into position. Center coupler ensuring rebar marks (completed in step 1)
line up correctly.
Step 5 : Tighten bolts per product instruction sheet IP8515.
Step 3B:
Step 4B:
TECHNICAL SUPPORT:
www.nVent.com
PDF139_A
INSTRUCTION SHEET
2 of 2
nVent, nVent CADDY, nVent ERICO Cadweld, nVent ERICO Critec, nVent ERICO, nVent ERIFLEX, and nVent LENTON are registered trademarks
of nVent or its global affiliates. All other trademarks are the property of their respective owners. nVent reservers the right to change
specifications without prior notice.
© 2019 nVent All Rights Reserved