Octane Fitness Q37x User manual

Q47x/Q47xi Service Guide
octanefitness.com Latin America/Asian Pacific
USA & Canada 001-763-757-2662
888-OCTANE4 Europe/Middle East/Africa
Version 1 © Dec 2013 Octane Fitness. All rights reserved. 31-10-2662412
Q37x/Q37xi Service Guide
Q37x/Q37xi Console Service Tips
Removing the Console Back Cover
You must remove the console back cover to troubleshoot connections or to update the firmware.
The back cover is secured by five (5) screws and by five (5) plastic tabs that snap the cover into
place.
Follow these instructions to carefully remove the back cover without breaking the tabs:
1. Remove the five (5) screws securing the back cover.
2. Carefully pull on the top of the back cover to disengage the retaining tabs. Pull the cover
away from the top, then from the bottom.
Updating the Firmware with a USB Flash Drive
Firmware updates on the Q37xi will be automatically installed by SMARTLINK, the Octane Fitness App. However, on
the Q37x, and for those owners not using SMARTLINK, there may be some occasions where a firmware update must be
installed from a USB flash drive. Follow these instructions:
1. Disconnect the power supply from the wall plug.
2. Remove the console back cover as directed above.
3. Insert the USB flash drive into the firmware update connection on the right side of
the console board.
4. Connect the power supply to the wall plug and allow the unit to power up.
5. Press and hold the Program Workout Skey and then press ENTER to begin the
firmware update process.
6. When the update is complete, remove the USB flash drive from the back of the
console.
7. Install the console back cover according to the instructions below.
Tabs
USB Port

octanefitness.com Latin America/Asian Pacific
USA & Canada 001-763-757-2662
888-OCTANE4 Europe/Middle East/Africa
Version 1 © Dec 2013 Octane Fitness. All rights reserved. 31-10-2662412
Q37x/Q37xi Service Guide
Installing the Console Back Cover
The back cover is secured by five (5) screws and by five (5) plastic tabs that snap the cover into place.
Follow these instructions to carefully install the back cover without breaking the tabs or stripping the threads on the screws:
1. Position the console back cover at an angle with the bottom two tabs
aligned in the console bottom.
2. Carefully press the console back cover up and snap the three top tabs
into the console cover.
3. Insert the CENTER SCREW first. This screw goes straight in; do not
insert at an angle. Tighten.
4. Insert the remaining four (4) screws at an upward angle. (If you insert
them straight in you will strip the threads.) Tighten.
e
e
d
c