Octane Fitness Q47x User manual

Q47x Console BoxBase Box
 Position top cover; hold back edge in place; shift front
edge forward and down.
 Press bottom edge to snap cover into place; secure
with B-5 (Qty 2).
 Wrap mast boot around mast; tuck into access panel.
107949-001 REV A
©2013 Octane Fitness. All rights reserved.
USA & Canada
888-OCTANE4
Latin America/Asian Pacific
001-763-757-2662
Europe/Middle East/Africa
31-10-2662412
Questions?
octanefitness.com
Pedal
Lever
A
Moving Handlebars
&
Adjustment
B
Information Packet
Base
Assembly Instructions
Base Hardware


Loosen screws on sides of lower shroud.
 Fit metal plate behind back shroud and side tabs into
slots over side screws. Secure back with B-4 (Qty 2);
tighten side screws.
Place handelbar covers.


Level &
User Set-up
F
Handlebar
Covers (2)
Q47xi Console Box
Information
Packet
Power Supply
Wireless Heart Rate
Transmitter and Strap
B-7
Console Hardware
Top Cover &
Mast Boot
E
D
Access Panel &
Handlebar Covers





Console Hardware

Powerband
Handle (2)
make sure nut is tight.
Adjust and lock levelers;
 Connect power supply to unit and to power outlet.
 Complete User Set-up (press and hold Level (/) —
See Operations Manual for instructions.
 Before 1st use and as needed, clean tracks with
a cloth and a solution of mild soap and water.
Console Assembly Console Assembly
Access Panel
B-1
(4)
B-4
(2)
#2 Phillips
B-5
(2)
#2 Phillips

B-6
Console
Mast
Mast
Boot
Moving Handlebars
(L and R)
Right
Pedal
Lever
Top Cover
Power Supply
Powerband (2)
Remove bolt from 3-pivot link.
Attach pedal lever; tighten to 33 ft-lb.


Attach handlebar at hub with B-1 (Qty 2), B-2 (Qty 2),
B-3 (Qty 1). Tighten to (30 ft-lb).
Connect heart rate and control button cables.
Repeat for second handlebar.
Mast &
Console
Assembly
C

















Mi
Boost
your
Workout
Console
Back
Console
Back
Mi
#2 Phillips
C-2 (5)
#2 Phillips
C-1 (4)
B-2
(4)
B-3
(2)

#2 Phillips
C-2 (5)
17mm
#2 Phillips
C-1 (4)
Slide mast over screws on base; tighten.
Connect cable connector (mast to base, Qty 1); secure
cables to frame with B-6.
Route heart rate cable through rear hole in mast and
connect to base cable.
Connect console cables (2) and ground cable. Position
console assembly over top of mast; attach with C-1
(Qty. 4). Connect power supply to unit and to power
outlet. Verify that console LEDs light and stride motors
move.
 Align console back with console assembly. Snap
console back and console assembly together at top.
Secure console back with C-2 (Qty 5).
Optional: Adjust moving handlebars for 2” longer / shorter reach:
Hold handlebar; remove nut and reposition link. (Hole
closest to user provides shortest rech.)
Replace nut; tighten (17 ft-lb).
Repeat for second handlebar. Handlebars must be set to
same position for proper functioning. Call Customer Service
for assistance as needed.
