STARTER 2200 Bench pH Meter EN-1
TABLE OF CONTENTS
1INTRODUCTION...................................................................2
1.1 Definition of Signal Warnings and Symbols...................................... 2
1.2 Safety Precautions............................................................................ 3
1.3 Package contents.............................................................................. 4
2INSTALLATION................................................................................. 5
2.1 Display and controls.......................................................................... 5
2.2 Installing the built-in electrode arm ................................................... 7
2.3 Installing power adapter.................................................................... 7
2.4 Installing the electrodes..................................................................... 8
3SETUP...................................................................................9
3.1 Set temperature unit and MTC value................................................ 9
3.2 Selecting a predefined buffer group.................................................. 9
4STARTER 2200 OPERATION.............................................10
4.1 Calibration....................................................................................... 10
4.1.1 Buffer group.............................................................................. 10
4.1.2 Reading Mode:......................................................................... 10
4.1.3 Performing 1-point calibration ...................................................11
4.1.4 Performing 2-point calibration...................................................11
4.2 Sample measurement..................................................................... 12
4.2.1 pH measurement...................................................................... 13
4.2.2 mV measurement..................................................................... 13
4.3 Temperature measurement............................................................. 13
4.4 Using the memory........................................................................... 14
4.4.1 Storing a reading...................................................................... 14
4.4.2 Recalling from memory ............................................................ 14
4.4.3 Clearing the memory................................................................ 14
5MAINTENANCE..................................................................15
5.1 Error message................................................................................. 15
5.2 Meter maintenance.......................................................................... 15
5.3 Electrode maintenance ................................................................... 16
5.4 Self-diagnosis.................................................................................. 16
5.5 Recover factory settings.................................................................. 16
6TECHNICAL DATA..............................................................17
6.1 Specifications.................................................................................. 17
7COMPLIANCE.....................................................................18
