Organized Living freedomRail 1 Drawer Double Hang Big OBox User manual

Tools Required
#2 Phillips
Screwdriver
#2 Phillips Driver
1
Over
(2)
freedomRail Assembly Instructions
1 Drawer Double Hang Big OBox
Left Side Right Side
Bottom
Top
Drawer Bottom
Drawer Front
Euroscrews
1 /" Wood Screws
Drawer Back
Drawer Side
Right Side
Drawer Side
Left Side
(1) Drawer Pull
Machine Screws
(For Drawer Pull)
(2) Full Extension Drawer Glides
(18)
(2)
(10)
Contents of Package
Connector Bolts
Hanging
Brackets
(2)
Proper Care for an OBox: Use Goo Gone™ or Simple Green® with a rag or putty knife to remove any excess glue or marring that was caused by shipping or assembly.
Power Drill
Cam
Lock
Open
Top
Step 3: Attach Sides
(a) Attach Sides to Bottom. (b) Lock Cam by turning clockwise until snug.
Step 4: Attach Top
(a) Attach Top. (b) Tighten Cams same as in Step 3.
AlignArrowWithHole.
Assembling the 1 Drawer Double Hang Big OBox
Step 1: Attach Hanging Brackets
Left Side Right Side
Back Edge Back Edge
Attach Hanging Brackets to sides using Euroscrews. (If using power drill, set torque to low setting.)
Step 2: Insert Connector Bolts
Bottom
Smaller Holes for
Connector Bolts
Insert (4) Connector Bolts into small holes on Top and Bottom Panels.

Attaches to Big OBox
(a) Lock Cam by turning clockwise / turn Turn until snug
(b) Attach Inner Glide to Drawer with Euroscrews. Notched End should be at back.
(c) Attach Handle with Machine Screws.
June 2018
7315-4130
Assembly Instructions
1 Drawer Double Hang Big OBox
Installing Glides
Step 5: Separate Glides
Bumper
Black Tab
Outer Glide Inner Glide
(a) Pull out Inner Glide to expose Black Tab.
(b) Separate Inner Glide from Outer Glide by pushing the Black Tab while pulling Glide sections apart.
Attaches to Drawer
Step 6: Attach Outer Glides to Double Hang Big OBox
Turn Double Hang Big OBox on its side. Attach Outer Glides with Euroscrews.
Install Outer Glides in Hole 3. Repeat for other side.
Mount Double Hang Big OBox onto Uprights by interting Hanging Brackets
into the innermost track of each Upright.
Step 7: Mount Double Hang Big OBox on Uprights
Step 8: Attach Drawer Panels
Assembling/Inserting Drawer
(a) Attach Sides to Back. (b) Secure with 1/" Wood Screw. (c) Slide in Bottom. Screw in Connector Bolts and attach Front.
Step 10: Attach Drawer Glides and Drawer Pull
Notched
End
Step 9: Attach Front Panel Connectors
(a) Position Drawer on Glides and push in Drawer completely.
NOTE: To remove Drawers, push the Black Tab while pulling out the Drawer.
Step 11: Insert Drawer
2
OrganizedLiving.com
1-800-669-3225
©2018 Organized Living
Bloomington, IN 47403
Bumper
Double Hang Big OBox Front