Organized Living freedomRail Cubby GOBox User manual

Backing
Horizontal
(20)
(4)
(16)
Hanging
Brackets
Euroscrews
Connector Bolts
Left Side Right Side
Top and Bottom
Install (8) Connector Bolts into small holes on Top and Bottom Panels.
Assembling the Cubby GOBox
Smaller Holes for
Connector Bolts
Step 2: Install Connector Bolts
Vertical
Attach Hanging Brackets to Sides using Euroscrews. (If using power drill, set torque to low setting.)
Back Edge Back Edge
Right Side
Left Side
Step 1: Attach Hanging Brackets
Vertical
freedomRail Garage Assembly Instructions
Cubby GOBox
Tools Required
Power Drill #2 Phillips
Screwdriver
#2 Phillips Driver Hammer
Contents of Package
Left Side Right Side
1
Proper Care for an OBox: Use Goo Gone™ or Simple Green® with a rag or putty knife to remove any excess glue or marring that was caused by shipping or assembly.
Over
Top and Bottom
Backing Nails
(16)
Step 3: Attach Sides and Verticals
Lock
Cam
Open
a
a
b
(a) Attach Sides and Verticals to Bottom. (b) Lock Cams by turning clockwise until snug.
AlignArrowWithHole.

OrganizedLiving.com
1-800-669-3225
June 2018
7315-2003
©2018 Organized Living
Bloomington, IN 47403
2
freedomRail Garage Assembly Instructions
Cubby GOBox
Insert the Horizontal section into the Cubby.
Step 5: Insert Horizontal
Install Backing with Nails provided into Top and Bottom Panels only.
Step 6: Install Backing
a
Step 7: Install onto Uprights
(a) Mount Cubby GOBox onto Uprights by inserting Hanging Brackets into the innermost track of each Upright.
Two people recommended for installation.
(a) Attach Top. (b) Lock Cams by turning clockwise until snug.
Step 4: Attach Top
a
b
Top