Organized Living freedomRail Doors for GOLocker User manual

Step 2: Install 2 Hinge Plates on Each Side of Cabinet
(2) Doors
(2) Handles
freedomRail Garage Assembly Instructions
Doors for GOLocker
Installing the Doors
Contents of Package
1" Machine Screws
(For Handles)
(4)
Power Drill
#2 Phillips
Screwdriver
#2 Phillips Driver
Tools Required
Place Hinge Plate into Cabinet by aligning Euro Screws with Top and Bottom
Pairs of Holes. Tighten Euro Screws to secure Hinge Plate.
Over
Proper Care for an OBox: Use Goo Gone™ or Simple Green® with a rag or putty knife to remove any excess glue or marring that was caused by shipping or assembly.
(4) Soft Close Hinge Assembly
and Hinge Plates
Step 1: Attach Two Hinge Assemblies
to Each Door
Press Cup into large hole.
Align screw holes. Insert and tighten wood screws.
1
Step 3: Attach Hinge Assembly and Door
to Hinge Plates in the Cabinet.
(a) Attach Hinge Assembly into Hinge Plates (See Detail A).
(b) Rotate Hinge Assembly until it snaps into
place. NOTE: Depending on the installation of the
Doors, there will be (2) holes at the top left or
bottom right corner of the Door.
Snap
Detail A Top View
Hinge Assembly and Door
Hinge Plate on GOBox

freedomRail Garage Assembly Instructions
Doors for GOLocker
Page 2
Step 4: Install the Two Handles
Step 5: Adjusting the Doors Detail B
Hinge Assembly has 3-way adjustment: (a) Front to back. (b) Top to bottom. (c) Side to side.
(a) Adjust Hinge Assembly to align doors. (See Detail B.)
2
OrganizedLiving.com
1-800-669-3225
October 2018
7315-5002
©2018 Organized Living
Bloomington, IN 47403
(a) Attach each Handle using (2) 1" Machine Screws.