Organized Living GOLocker User manual

Backing Nails
Shelf
Screws Shelf
Pins
Hanging
Brackets
freedomRail Garage Assembly Instructions
GOLocker
Contents of Package Tools Required
Power Drill
#2 Phillips
Screwdriver
#2 Phillips Driver
(4)
(4)
Connector Bolts
(8)
(12)
(20) Euroscrews
(2) Shelves
(2) Cleats
Bottom
Top
Middle
Left Side
Right Side
Locker Back
Assembling the GOLocker
Step 1: Attach Hanging Brackets, Shelf Screws, and Connector Bolts to Sides
Bottom Edge Bottom Edge
(16)
Attach (4) Hanging Brackets to Sides using Euroscrews.
Attach (4) Shelf Screws and (4) Connecting Bolts near bottom. (If using power rrill, set torque to low setting.)
Insert (6) Connector Bolts into small holes on Locker Top.
Step 2: Insert Connector Bolts into Top
Step 3: Attach Sides and Middle
(a) Attach Sides and Middle to Top. (b) Tighten Cams by turning
clockwise until snug.
Top
Lock
Cam
Open
Insert (2) Connector Bolts into small holes on Locker Bottom.
1
Over
Proper Care for an OBox: Use Goo Gone™ or Simple Green® with a rag or putty knife to remove any excess glue or marring that was caused by shipping or assembly.
Hammer
Left Side Right Side
Locker Top
Smaller holes for
Connector Bolts
Step 4: Insert Connector Bolts on Locker Bottom
Locker Bottom
AlignArrowWithHole.

Step 5: Attach Bottom and Cleats
Turn Cam to Lock
Top
(a) Attach Locker Bottom to middle and tighten Cams on Middle section. Do not
tighten Cams on Locker Bottom. (b) Insert Locker Cleat one end at a time.
Step 7: Install Back
Install Backing with Nails provided into Top and Bottom Panel only.
OrganizedLiving.com
1-800-669-3225
June 2018
7315-5001
©2018 Organized Living
Bloomington, IN 47403
2
freedomRail Garage Assembly Instructions
GOLocker
(a) Turn all Cams on Cleats to lock down. (b) Tighten all Cams on locker Bottom.
Step 6: Lock Down Cleat
Turn Cam to Lock
Step 8: Install onto Uprights, Install Shelves
(a) Install Locker on Uprights by inserting Hanging Brackets into innermost slots on
the Uprights. Two people recommended for installation. (b) Install Shelf Pins into
hole pattern where shelf is desired. Insert Shelf onto Shelf Pins.