Organized Living freedomRail 1 Drawer Double Hang OBox User manual

Top
Contents of Package
Euroscrews
(18)
1 /" Wood Screws
Connector Bolts
Hanging
Brackets
(2) Full Extension Drawer Glides
(1) Drawer Pull
Machine Screws
(For Drawer Pull)
Tools Required
Power Drill
#2 Phillips
Screwdriver
#2 Phillips Driver
Right Side
Top
Left Side
Bottom
Drawer Back
Drawer Front
Drawer Bottom
Drawer
Left Side
Drawer
Right Side
(4)
(2)
(10)
(2)
freedomRail Assembly Instructions
1 Drawer Double Hang OBox
Assembling the 1 Drawer Double Hang OBox
Step 1: Attach Hanging Brackets
Left Side Right Side
Back Edge Back Edge
Attach Hanging Brackets to Sides using Euroscrews. (If using power drill, set torque to low setting.)
Step 2: Install Connector Bolts
Smaller Holes for
Connector Bolts
Step 3: Attach Sides
(a) Attach Sides to Bottom. (b) Tighten Cams by turning clockwise until snug. (a) Attach Top. (b) Tighten Cams by turning clockwise until snug.
Install (4) Connector Bolts into small holes on Top and Bottom.
1
Over
Proper Care for an OBox: Use Goo Gone™ or Simple Green® with a rag or putty knife to remove any excess glue or marring that was caused by shipping or assembly.
Bottom
Step 4: Attach Top
AlignArrowWithHole.
Cam
Lock
Open

Step 7: Mount Double Hang OBox onto Uprights
(b) Separate Inner Glide from Outer Glide by pushing Black Tab while pushing the Black Tab while pulling Glide section apart.
freedomRail Assembly Instructions
1 Drawer Double Hang OBox
Installing Glides
Assembling/Inserting the Drawers
Step 5: Separate Glides
(a) Pull out Inner Glide to expose Black Tab.
Turn Double Hang OBox on its side. Attach Outer Glides with Euroscrews.
Install Outer Glides in hole 3. Repeat for other side.
Mount Double Hang OBox onto Uprights by inserting Hanging
Brackets into the innermost track of each Upright.
Step 6: Attach Outer Glides to Double Hang OBox
(a) Attach Sides to Back. (b) Secure with 1/" Wood Screws. (c) Slide in Bottom.
Step 8: Attach Drawer Panels
(a) Lock Cam by turning clockwise / turn. Turn until snug.
(b) Attach Inner Glides to Drawer with Euroscrews. Notched End should be at back.
(c) Attach Drawer Pull with Machine Screws.
Screw in Connector Bolts and attach Front.
Step 11: Insert Drawers
Position Drawer on Glides and push in Drawer completely.
Repeat Steps 8, 9, 10, and 11 for second Small Drawer.
NOTE: To remove Drawers, push the Black Tab while pulling out the drawer.
Bumper
Outer Glide Black Tab Inner Glide
Attaches to Drawer
Attaches to OBox
Bumper
Double Hang OBox Front
1
2
3
Step 9: Attach Front Panel Connectors
©2018 Organized Living
Bloomington, IN 47403
OrganizedLiving.com
1-800-669-3225
June 2018
7315-1124
2
Step 10: Attach Drawer Glides and Drawer Pull
Notched
End