Organized Living freedomRail 2 Drawer Double Hang Big OBox User manual

Left Side
Right Side
(2) Drawer Pulls
Machine Screws
(For Drawer Pulls)
(2) Full Extension Drawer Glides
(4)
(a) Attach Sides to Bottom. (b) Lock Cam by turning clockwise until snug.
Right Side
Back Edge Back Edge
freedomRail Assembly Instructions
2 Drawer Double Hang Big OBox
Contents of Package
(26)
(4)
(12)
(2)
Euroscrews
1/" Wood Screws
Connector Bolts
Hanging
Brackets
Bottom
Top
(2) Drawer Bottoms
(2) Drawer Fronts
(2) Drawer Backs
(2)
Drawer
Right
Sides
(2)
Drawer
Left
Sides
Assembling the 2 Drawer Double Hang Big OBox
Step 1: Attach Hanging Brackets
Left Side
Attach Hanging Brackets to sides using Euroscrews. (If using power drill, set torque to low setting.)
Bottom
Smaller Holes for
Connector Bolts
Step 2: Insert Connector Bolts
Step 3: Attach Sides Step 4: Attach Top
Insert (4) Connector Bolts into small holes on Top and Bottom Panels.
Lock
Cam
Open
(a) Attach top. (b) Tighten Cams same as in Step 3.
1
Over
Proper Care for an OBox: Use Goo Gone™ or Simple Green® with a rag or putty knife to remove any excess glue or marring that was caused by shipping or assembly.
Tools Required
#2 Phillips
Screwdriver
#2 Phillips Driver
Top
Power Drill
AlignArrowWithHole.

Installing Glides
freedomRail Assembly Instructions
2 Drawer Double Hang Big OBox
Step 5: Separate Glides
Bumper
Outer Glide Black Tab Inner Glide
(a) Pull out Inner Glide to expose Black Tab.
Attaches to Drawer
Attaches to Big OBox
(b) Separate Inner Glide from Outer Glide by pushing the Black Tab while pulling Glide section apart.
Step 6: Attach Outer Glides to Double Hang Big OBox
Turn Double Hang OBox on its side. Attach Outer Glides with Euroscrews.
Install Outer Glides in holes 1 and 3. Repeat for other side.
Step 7: Mount Double Hang Big OBox on Uprights
Mount Double Hang Big OBox onto Uprights by inserting Hanging Brackets
into the innermost track of each Upright.
Notched
End
Step 10: Attach Drawer Glides and Drawer Pull Step 11: Insert Drawers
(a) Position Drawer on Glides and push in Drawer completely. Repeat Steps 8, 9, 10, and 11 for
second Small Drawers. NOTE: To remove drawers, push the black tab while pulling out the drawer.
(a) Lock Cam by turning clockwise ¼ turn. Turn until snug.
(b) Attach Inner Glides to Drawer with Euroscrews. Notched End should be at back.
(c) Attach Drawer Pull with Machine Screws.
©2018 Organized Living
Bloomington, IN 47403
OrganizedLiving.com
1-800-669-3225
June 2018
7315-4230
2
Bumper
1
2
3
Double Hang Big OBox Front
(a) Attach Sides to Back. (b) Secure with 1⁄" Wood Screws. (c) Slide in Bottom.
Assembling/Inserting Drawers
Step 8: Attach Drawer Panels Step 9: Attach Front Panel Connectors
Screw in Connector Bolts and attach Front.