Organized Living freedomRail 2 Drawer Double Hang OBox User manual

freedomRail Assembly Instructions
2 Drawer Double Hang OBox
Contents of Package
Assembling the 2 Drawer Double Hang OBox
Euroscrews
(26) (2)
(12)(4) 1 /" Wood Screws Connector Bolts Hanging
Brackets
(4) Full Extension Drawer Glides
(2) Drawer Pulls
Machine Screws
(For Drawer Pulls)
(4)
Tools Required
Power Drill
#2 Phillips
Screwdriver
#2 Phillips Driver
Step 1: Attach Hanging Brackets
Left Side Right Side
Back Edge Back Edge
Attach Hanging Brackets to Sides using Euroscrews. (If using power drill, set torque to low setting.)
Step 2: Install Connector Bolts
Bottom
Smaller Holes for
Connector Bolts
Step 3: Attach Sides
Cam
Lock
Open
(a) Attach Sides to Bottom. (b) Tighten Cams by turning clockwise until snug. (a) Attach Top. (b) Tighten Cams by turning clockwise until snug.
Step 4: Attach Top
Top
Install (4) Connector Bolts into small holes on Top and Bottom Panels.
1
Over
Proper Care for an OBox: Use Goo Gone™ or Simple Green® with a rag or putty knife to remove any excess glue or marring that was caused by shipping or assembly.
Left Side Right Side
Top
Left Side
Bottom
(2) Drawer Backs
(2) Drawer Fronts
(2) Drawer Bottoms
(2)
Drawer
Left
Sides
(2)
Drawer
Right
Sides
AlignArrowWithHole.

Step 10: Attach Drawer Panels
Step 7: Mount Double Hang OBox onto Uprights
Mount Double Hang OBox onto Uprights by inserting Hanging Brackets into the innermost track of each Upright.
Installing Glides
Assembling/Inserting Drawers
freedomRail Assembly Instructions
2 Drawer Double Hang OBox
Step 5: Separate Glides
(a) Pull out Inner Glide to expose Black Tab.
(b) Separate Inner Glide from Outer Glide by pushing Black Tab while pushing the Black Tab while pulling Glide section apart.
Turn Double Hang OBox on its side. Attach Outer Glides with Euroscrews.
Install Outer Glides in holes 1 and 3. Repeat for other side.
Step 6: Attach Outer Glides to Double Hang OBox
Step 8: Attach Outer Glides to Double Hang OBox
(a) Attach Sides to Back. (b) Secure with 1 /" Wood Screws. (c) Slide in Bottom.
(a) Lock Cam by turning clockwise / turn. Turn until snug.
(b) Attach Inner Glides to Drawer with Euroscrews. Notched end should be at back.
(c) Attach Drawer Pull with Machine Screws.
Step 9: Attach Front Panel Connectors
Screw in Connector Bolts and attach front.
Step 11: Insert Drawers
Position Drawer on Glides and push in Drawer completely.
Repeat Steps 8, 9, 10, and 11 for second Small Drawer.
NOTE: To remove Drawers, push the Black Tab while pulling out the Drawer.
©2018 Organized Living
Bloomington, IN 47403
OrganizedLiving.com
1-800-669-3225
June 2018
7315-1224
Bumper
Outer Glide Black Tab Inner Glide
Attaches to Drawer
Attaches to OBox
Bumper
Notched
End
2
1
2
3
Double Hang OBox Front