Organized Living freedomRail Garage GOCabinet User manual

(2) Shelves
Top and Bottom
(20)
Euroscrews
Shelf Screws
(8)
Connector Bolts
(8)
Hanging
Brackets
(4)
freedomRail Garage Assembly Instructions
GOCabinet
Contents of Package
Assembling the GOCabinet
Step 1: Attach Hanging Brackets
Right Side
Left Side
Back Edge Back Edge
Attach Hanging Brackets to Sides using Euroscrews. (If using power drill, set torque to low setting.)
Step 2: Install Connector Bolts
Top and
Bottom
Smaller Holes for
Connector Bolts
Install (4) Connector Bolts into small holes on Top and Bottom.
Step 3: Attach Sides
(a) Attach Sides to Bottom.
(b) Tighten Cams by turning clockwise until snug.
Cam
Lock
Open
Step 4: Attach Top
(a) Attach Top. (b) Tighten Cams by turning clockwise until snug.
Apply Cover Caps to expose Cams.
Top
Over
1
Backing Nails
(16)
Left Side
Right Side
Cabinet Back
Tools Required
Power Drill
#2 Phillips Driver
Hammer
Proper Care for an OBox: Use Goo Gone™ or Simple Green® with a rag or putty knife to remove any excess glue or marring that was caused by shipping or assembly.
#2 Phillips
Screwdriver
AlignArrowWithHole.

freedomRail Garage Assembly Instructions
GOCabinet
Step 5: Attach Shelf Screws
Turn GOCabinet on its Side. Insert (4) Shelf Screws into Left Side. Repeat for Right Side. (a) Install Shelves onto Shelf Screws, nished edge toward front.
(b) Tighten Cams on Bottom of Shelf.
Step 6: Insert and Fasten Shelves
Install Backing with Nails provided onto Top and Bottom only.
Step 7: Install Backing
(a) Mount GOCabinet onto Uprights by inserting Hanging Brackets into the innermost
track of each Upright. Two people recommended for installation.
Step 8: Install onto Uprights
OrganizedLiving.com
1-800-669-3225
June 2018
7315-3001
©2018 Organized Living
Bloomington, IN 47403
2