Organized Living freedomRail Garage User manual

Smaller Holes for
Connector Bolts
Install (4) Connector Bolts into small holes on Top and Bottom Panels.
(a) Attach Top. (b) Lock Cams by turning clockwise until snug.
Attach Hanging Brackets to Sides using Euroscrews. (If using Power Drill, set torque to low setting.)
(a) Attach Sides and Verticals to Bottom. (b) Lock Cams by turning clockwise until snug.
freedomRail Garage Assembly Instructions
1 Shelf GOBox
Tools Required
Power Drill #2 Phillips
Screwdriver
#2 Phillips Driver Hammer
Step 3: Attach Sides
Lock
Cam
Open
Assembling the 1 Shelf GOBox
Top
Step 2: Install Connector Bolts
Back Edge Back Edge
Right Side
Left Side
Step 1: Attach Hanging Brackets
Proper Care for an OBox: Use Goo Gone™ or Simple Green® with a rag or putty knife to remove any excess glue or marring that was caused by shipping or assembly.
Over
Contents of Package
Step 4: Attach Top
Top and Bottom
(a) Attach Sides to Bottom. (b) Tighten Cams by turning clockwise until snug. (a) Attach Top. (b) Tighten Cams by turning clockwise until snug.
1
Left Side
Right Side
Backing
Shelf
Top and Bottom
(20) Euroscrews
(16) Backing Nails
Connector Bolts
(8)
Hanging
Brackets
(4)
Shelf
Screws
(4)

freedomRail Garage Assembly Instructions
1 Shelf GOBox
OrganizedLiving.com
1-800-669-3225
June 2015 ©2015 Organized Living
Bloomington, IN 47403
Step 8: Install onto Uprights
(a) Mount GOBox onto Uprights by inserting Hanging Brackets into the innermost track of
each Upright. Two people recommended for installation.
Insert the Backing with Nails provided into Top and Bottom Panels only.
Step 6: Install Backing
2
Step 5: Install Shelf Screws
Turn GoBox on its side. Install Shelf Screws into Left Side. Repeat for Right Side.
Step 6: Insert and Fasten Shelf
(a) Insert Shelf onto Shelf Screws, nished edge toward front. (b) Turn Cams clockwise on
Shelf bottom to lock.