Organized Living freedomRail GOCabinet User manual

freedomRail Garage Assembly Instructions
Doors for GOCabinet
Contents of Package
#2 Phillips
Screwdriver
#2 Phillips Driver
Tools Required
Installing the Doors
Over
(2) Doors Power Drill
Proper Care for an OBox: Use Goo Gone™ or Simple Green® with a rag or putty knife to remove any excess glue or marring that was caused by shipping or assembly.
(2) Handles
1" Machine Screws
(For Handles)
(4)
(4) Soft Close Hinge Assembly
and Hinge Plates
Step 2: Install 2 Hinge Plates on Each Side of Cabinet
Step 1: Attach Two Hinge Assemblies
to Each Door
Press Cup into large hole.
Align screw holes. Insert and tighten wood screws.
1
Step 3: Attach Hinge Assembly and Door
to Hinge Plates in the Cabinet.
(a) Attach Hinge Assembly into Hinge Plates (See Detail A).
(b) Rotate Hinge Assembly until it snaps into
place. NOTE: Depending on the installation of the
Doors, there will be (2) holes at the top left or
bottom right corner of the Door.
Snap
Place Hinge Plate into Cabinet by aligning Euro Screws with Top and
Bottom Pairs of Holes. Tighten Euro Screws to secure Hinge Plate.
Detail A Top View
Hinge Assembly and Door
Hinge Plate on GOBox

freedomRail Garage Assembly Instructions
Doors for GOCabinet
Page 2
OrganizedLiving.com
1-800-669-3225
October 2018
7315-3002
©2018 Organized Living
Bloomington, IN 47403
(a) Attach each Handle using (2) 1" Machine Screws.
NOTE: Doors are easily ipped so that Handles may be placed either at the top
(for low Cabinets) or bottom of the Door (for high Cabinets).
Hinge Assembly has 3-way adjustment: (a) Front to back. (b) Top to bottom. (c) Side to side.
(a) Adjust Hinge Assembly to align Doors. (See Detail B.)
Step 4: Install the Two Handles
Step 5: Adjusting the Doors
(For High Cabinets) (For Low Cabinets)
Detail B