ORiNG IAP-W510 Plus User manual

ORing WLAN Access Point
Model IAP-W510+
10/100 Base-T(X) Ports in
RJ45 Auto MDI/MDIX with
IEEE802.3af PoE P.D.
1
Physical Ports
Technology
Modulation
Power
Input power
Power consumption(Typ.)
48 VDC IEEE802.3af Power over Ethernet
9 Watts
Physical Characteristic
Enclosure IP-67
Dimension(WxDxH) 162(W) x 102(D) x 58(H) mm (6.38 x 4.02 x2.28inch.)
Weight (g) 680 g
Environmental
-30to85C(-22to185F)
oo
Storage Temperature
-20to70C(-4to158F)
oo
Operating Temperature
Regulatory Approvals
FCC Part 15, CISPR (EN55022) class A
EMI
EN61000-4-2 (ESD), EN61000-4-3 (RS), EN61000-4-4 (EFT), EN61000-4-5 (Surge),
EN61000-4-6 (CS), EN61000-4-8, EN61000-4-1
EMS
IEC60068-2-27
Shock
IEC60068-2-32
IEC60068-2-6
Vibration
Free Fall
Warranty
3 years
WLAN Interface
Operating Mode AP/Bridge/Repeater/AP-Client/Client
Antenna Connector Build-in 15dBi panel antenna
Radio Frequency Type OFDM
Frequency Band
Transmission Rate IEEE802.11a: 6/ 9/ 12/ 18/ 24/ 36/ 48/ 54 Mbps
IEEE802.11n: 300Mbps
Encryption Security
WEP: (64-bit, 128-bit key supported)
WAP/WAP2: 802.11 (WEP and AES encryption)
WAP-PSK (256-bit key pre-shared key supported)
802.1X Authentication supported
TKIP encryption
Wireless Security SSID broadcast disable
Features
High Speed Air Connectivity: WLAN interface support up to
300Mbps link speed
Highly Security Capability: WEP/WPA/WPA-PSK(TKIP,AES)/
WPA2/WPA2-PSK(TKIP,AES)/802.1X Authentication supported
High throughput > 80Mbps
High output power 500mw
Far Distance Air Connectivity up to 7KM (IAP-W510+)
Support X-Roaming < 100ms
Support AP/Bridge/Repeater/AP-Client/Client Mode
Wireless connecting status monitoring
HTTPs protocol supported for secured management
IP table to prevent unauthorized IP address from accessing
Event Warning by Syslog, Email, SNMP Trap
Rigid IP-67 housing design
Pole-mount enabled
s a reliable IP-67 outdoor IEEE 802.11 a/n
WLAN Access Point with 1 PoE P.D. Ethernet port. It can be
configured to operate in AP/Bridge/Repeater/AP-Client/Client mode.
It is specifically designed for the toughest industrial environments. In
combination with its IP-67 design and the superb management
functionality, provides a waterproof, dust-tight
connection. In addition, provides high power output of
500mw and high throughput up to 80Mbps to satisfy far distance
connection. provides two N-type connectors, which can
install any N-type antennas to extend communication distance. You
are able to configure by WEB interface via LAN
port or WLAN interface. In addition, also
provides P.D. feature which is fully compliant with IEEE802.3af PoE P.D.
specification to save the layout cost of power line The
can be easily adopted in almost all kinds of applications and
provides the most rugged solutions for managing your network in
outdoor. Therefore, is one of the best outdoor
communication solutions for wireless applications
IAP-W510+ / W512+ i
IAP-W510+ / W512+
IAP-W510+
IAP-W512+
IAP-W510+ / W512+
IAP-W510+/W512+
. IAP-W510+ /
W512+
IAP-W510+ / W512+
Introduction SpecificationsApplications
QIG Quick Installation Guide
In practical operation of wireless access point, Windows utility (Open-Vision) is
supported. This utility is very helpful for you to search IP and configure settings of
access point on the industrial wireless network. In addition, the wireless access point
support various kinds of operation modes include AP Bridge/ Repeater/ AP-Client/
Client mode. IAP-W510+ also can connect with each other up to 7,000 meters with
built-in panel antenna.
Transmit Po w e r IEEE802.11a/n: 500mW Max
Receiver Senstivity
-82dBm @ 54Mbps, PER< 10%;
-78dBm @ MCS 15(11n, 20MHz), PER<10%;
-75dBm @ MCS 15(11n, 40MHz), PER<10%;
Version 1.0
Quick Installation Guide
ORing Industrial Networking Corp.
IAP-W510+/W512+
IAP-W510+/W512+ PRINTED ON RECYCLED PAPER
IEEE802.11a:OFDM with BPSK, QPSK, QAM, 64QAM
IEEE802.11n : BPSK, QPSK, 16-QAM, 64-QAM
America / FCC: 5.15 to 5.825 GHz (13 channels)
Europe / ETSI: 5.15 to 5.724 GHz (19 channels)
ORing Industrial Networking Corp.
Copyright© 2012 ORing
All rights reserved.
TEL: [phone]
FAX: [phone]
Website: www.oring-networking.com
E-mail: [email protected]
Various kinds of operation modes
Protocol Support
Protocol ARP,BOOTP, DHCP, DNS, HTTPs, IP, ICMP, SNTP, TCP, UDP, RADIUS, SNMP, STP (IEEE 802.1D)
LED Indicators
Power indicator
10/100Base-T(X) RJ45 port
indicator
PWR/Ready:1xLED
Green On: Power is on and functioning Normally.
1xLED,
Green On: Port Link
Green Blinking: Transmitting data
WLAN 1xLED,GreenforWLANLink/Act
EN60950-1
Safety
Industrial IP-67 PoE Outdoor Access
Point
IAP-W512+
2 x External N-type antenna connector
162(W) x 102(D) x 48(H) mm (6.38 x 4.02 x 1.89 inch.)
1907-2-29-IAPW51X+-0
100% Non-condensing
Operating Humidity
Wireless
ACCESS POINT
IP-67
PoE

Front Panel Accessory
RJ-45 Rubber Seal
1
Pole-mounted kit
3
CD
4QIG
5
QIG
Quick Installation Guide
ORing Industrial Networking Corp.
Quick Installation Guide
10/100 Base-T(X) RJ45
Installation
Pole-mounted Install Step
Pole
PRINTED ON RECYCLED PAPER
Power LED
10/100 LAN Port LED
WLAN LED
Build-in
panel antenna (IAP-W510+ Only)
Industrial outdoor IEEE 802.11 a n wireless access
point with 1x10/100Base-T(X), IP-67 grade,
band
/
EU
Packing list
Description Accessory
1X1, 3X2, 4X1,
IAP-W510+_EU
Model name
IAP-W510+_US
Industrial outdoor IEEE 802.11 a n wireless access
point with 1x10/100Base-T(X), IP-67 grade,
US band
/
N-type RF connector
(IAP-W512+ only ) N-type ANT. Rubber Seal
2
Industrial outdoor IEEE 802.11 a n wireless access
point with x10/100Base-T(X), IP-67 grade, N-type
antenna connector, US band
/
1
IAP-W512+_US
IAP-W512+_EU
Industrial outdoor IEEE 802.11 a n wireless access
point with x10/100Base-T(X), IP-67 grade, N-type
antenna connector, EU band
/
1
Internal Antenna
(IAP-W510+ Only)
Quick Installation Guide
5X1
1X1, 2X2, 3X2,
4X1, 5X1
IAP-W510+/W512+
IAP-W510+/W512+
Industrial IP-67 PoE Outdoor Access
Point
Wireless
ACCESS POINT
IP-67
PoE
Version 1.0
1X1, 3X2, 4X1,
5X1
1X1, 2X2, 3X2,
4X1, 5X1