Panasonic ET-ACF100 Guide

Replacement Instructions
ACF unit for Projector
R
ET-ACF100Model No.
TQZJ 038-2
These symbols on the products, packaging, and/or accompanying
documents mean that used electrical and electronic products and
batteries should not be mixed with general household waste.
For proper treatment, recovery and recycling of old products and used
batteries, please take them to applicable collection points, in accordance
with your national legislation and the Directives 2002/96/EC and
2006/66/EC.
By disposing of these products and batteries correctly, you will help to
save valuable resources and prevent any potential negative effects on
human health and the environment which could otherwise arise from
inappropriate waste handling.
For more information about collection and recycling of old products and
batteries, please contact your local municipality, your waste disposal
service or the point of sale where you purchased the items.
Penalties may be applicable for incorrect disposal of this waste, in
accordance with national legislation.
Information for Users on Collection and Disposal of Old Equipment and
used Batteries
For business users in the European Union
If you wish to discard electrical and electronic equipment, please contact
your dealer or supplier for further information.
[Information on Disposal in other Countries outside the European
Union]
These symbols are only valid in the European Union. If you wish to
discard these items, please contact your local authorities or dealer and
ask for the correct method of disposal.
Note for the battery symbol (bottom two symbol examples):
This symbol might be used in combination with a chemical symbol.In this
case it complies with the requirement set by the Directive for the
chemical involved.
Read these instructions completely before replacement.

Replacing the ACF
Precautions with regard to safety
CAUTION
Be sure to use the projector with the ACF unit installed.
Replacement procedure
2-ENGLISH
●
●
●
●
●
Soft cloth
ACF cover
ACF cover fixing screw
Before replacing the ACF
䎃
Press the power button twice to turn off the projector.
(The power indicator will turn orange.)
Wait until the cooling fan stops and the POWER indicator turn to RED.
Disconnect the mains plug from the mains socket.
Prepare a Phillips-head screw driver.
Indicated replacement procedure below is for F300 series projectors. For the
other series of projector, refer the Operating Instructions that is provided
with your projector.
1.Turn the projector upside down and place it gently on a soft cloth.
2. Use a Phillips-head screwdriver to loosen 3 ACF cover fixing screws until
the screws turn freely and remove the ACF cover.
Sucking dust or dirt may cause troubles to the projector.
If the ACF unit is not installed, power will be automatically shut down.

ENGLISH-3
4. Insert a new “ ACF unit ” into the compartment until it catches the both
locking detents.
5. Attach the ACF cover and tighten the ACF cover fixing screws securely
with a Phillips-head screwdriver.
6. Once the “ ACF unit ” has been replaced, press and hold the [ENTER]
button for about three seconds on the [FILTER COUNTER RESET]
submenu which can be selected from the [PROJECTOR SETUP] menu.
7. Press Ito select OK and press the ENTER button to reset the FILTER
REMAINING to "0".
Notice:
Use this product with the "ACF unit" installed. If you use the projector with-
out the unit, the power will be shut off in order to prevent a possible failure
due to the collected dust and dirt.
3. Hold the pushes of the locking detents inward with fingers to release the
lock, and pull out carefully the “ACF unit” from the body.
* When you replace the ACF unit, clean the compartment and/or the Air
exaust port if you need to.
ACF unit
Locking detents
Pushes
Pushes

https://panasonic.net/cns/projector/
Printed in Japan