Paradox TM40 User manual

Printed in Canada | 09/2011 TM40 Quick Install Guide
TM40 Touch Interface
Module
Quick Install Guide
Installation
1. Using a screwdriver, pry the front housing assembly from
the back plate.
2. Mount the back plate to the wall by securing a M3.5 or #6
screw in each of the dedicated mounting holes and tamper
hole. Ensure that the UP arrow on the back plate is in the up
position.
3. Assemble both items by joining the hooks on the back plate
to their respective slots on the front housing assembly.
NOTE: Make sure to connect the unit’s 5-pin connector before
proceeding to the next step.
Front housing
assembly
Hooks on
back plate
TM40-EI01

TM40 Quick Install Guide Printed in Canada | 09/2011
4. Secure the front housing assembly to the back plate by
snapping it into place.
The installation process is complete.
TM40 to Panel Connections
As shown in the Wiring Diagram, the red, black, green, and yellow
wires on the TM40 must be connected to their corresponding
labeled terminals on the control panel’s PCB. The blue wire is
connected to either a keypad zone or external temperature
sensor.
Wiring Diagram
Technical Specifications
Power Input 9 to 16 Vdc
Consumption 110 mA
Display 16-bit, color LCD; 5.4 x 9.5 cm (2.1 x 3.7 in.)
Resolution 480 x 272 pixels
Dimensions 12.4 x 8.1 x 1.6 cm (4.9 x 3.2 x 0.7 in.)
Weight 0.15 kg (0.33 lbs.)
Humidity 5-90%
Sensors Indoor temperature sensor
Standards Complies with EN 50131 Security Grade 3 Class II
CONTROL PANEL
BLUE
ZONE/TEMP
RED
BLK
GRN
YEL
Kpd 1 or Kpd 2
N.C . COM
AUX
-
GRN
YEL
AUX
+
Warranty: For complete warranty information on this product, please
refer to the Limited Warranty Statement found on the Web site
www.paradox.com/terms. Your use of the Paradox product signifies your
acceptance of all warranty terms and conditions.
© 2011 Paradox Ltd. All rights reserved. Specifications may change
without prior notice. www.paradox.com