Petsafe 2-in-1 Dog Kennel Installation guide

PetSafe®
2-in-1 Dog Kennel
Assembly Instructions
Instructions d’assemblage
Instrucciones de montaje
Please read this entire guide before assembly
Veuillez lire entièrement le guide avant assembleé
Por favor, lea completamente esta guía antes de asamblea
Option 1 - Dog Kennel
10'(W) x 10'(L) x 6'(H)
Option 1 - Enclos Carre
3.05m(W) x 3.05m(L) x 1.83m(H)
Opción 1 - Caseta cuadrada
3.05m(W) x 3.05m(L) x 1.83m(H)
Option 2 - Dog Run
5'(W) x 15'(L) x 6'(H)
Option 2 - Enclos Rectangulaire
1.52m(W) x 4.57m(L) x 1.83m(H)
Opción 2 - Caseta Rectangular
1.52m(W) x 4.57m(L) x 1.83m(H)

2 1-888-632-4453
Thank you for choosing PetSafe®. The relationship you have with your pet is the focus of
everything we do. If you have questions about, or are dissatisfied with, any of our products, please
contact the Customer Care Center at 1-888-632-4453 or visit our website at www.petsafe.net.
_________________________________________________________________________________________________________
Table of Contents
Components.............................................................................................................................................. 3
Tools Needed............................................................................................................................................ 3
Connect the Bottom Frame....................................................................................................................... 4
Add Uprights ............................................................................................................................................ 4
Add an Upright Post for the Gate.............................................................................................................. 5
AddTop Rails............................................................................................................................................ 6
Install the Gate.......................................................................................................................................... 6
Add fence fabric........................................................................................................................................7
Stretch the Fabric...................................................................................................................................... 7
Cut the Fabric........................................................................................................................................... 8
Secure the Fabric....................................................................................................................................... 8
Caution..................................................................................................................................................... 9
Terms of Use and Limitation of Liability ................................................................................................... 9
Français .........................................................................................................................10
Español ..........................................................................................................................16

www.petsafe.net 3
Components
Gate
BentTubing (Corner Rail)
Swedged on One End
8 pcs. Gate Latch
Clip
10 pcs.
End Rail Clamps
36 pcs.
TieWires
(100 pcs.)
Male Hinge
2 pcs.
Female Hinge
2 pcs.
63 1/8"Tubing (Frame Rail)
Swedged on One End
8 pcs.
68"Tubing Plain (Uprights)
9 pcs.
69"Tension Rods
2 pcs.
3/8x 2" Carriage Bolts
with Nut
4 pcs.
5/16 x 2" Carriage Bolts
with Nut
18 pcs.
1 Roll Chain Link Fabric
Assembly Insructions
Tools Needed
• Hammer
• AdjustableWrench
• Pliers
•Tape Measure

4 1-888-632-4453
Connect the Bottom Frame
Important: Assemble on a level surface.
1. Gather 4 corner rails and
4 frame rails.
2. Point all swedged ends
clockwise.
3. Slip swedged ends of
tubing into the next piece
of tubing.
Option 1 - Dog Kennel
10'(W) x 10'(L) x 6'(H)
Option 2 - Dog Run
5'(W) x 15'(L) x 6'(H)
__________________________________________________________________________________________________
Add Uprights
1. Gather 8 uprights, 16 clamps, 8 - 5/16" x 2" carriage bolts with nuts.
2. With the nut on top, loosely clamp all posts to the bottom frame at each corner and half way along each side
for Option 1, and one third of the way along the long sides for Option 2 (as shown below).
3. Stand corner posts up and tighten clamps. Let the center posts lie on the ground.
Option 1
Option 2
Step
1
Step
2

www.petsafe.net 5
__________________________________________________________________________________________________
Add an Upright Post for the Gate
1. Gather 1 upright, 2 clamps , and 1 - 5/16" x 2" carriage bolt with nut.
2. Install the gate post 22 ¼" to either side of the corner upright.
Important: Do NOT have the gate span a joint in the frame. The frame can come apart at the
swedged joint.
22 1/4"
Note: Gate Opening is 22 1/4" between posts. All swedged joints will be loose until fence fabric is installed.
Step
3

6 1-888-632-4453
AddTop Rails
1. Gather 4 corner rails, 4 frame rails, 18 clamps and 9 - 5/16" X 2" carriage bolts with nuts.
2. Point all top rail swedges clockwise the same as the bottom frame.
3. Connect rails to all posts (4A). Tighten all clamps as you go.
5A
Important: Check that all posts are straight up and down. Confirm that all nuts are tight.
____________________________________________________________________________________
Install the Gate
1. Gather male and female hinges, 4 - 3/8" X 2" carriage bolts with nuts, and the gate. Note: Gate can open
from either side.
2. Install the upper female hinge below the upper most gate clip (5B).
3. Install the lower female hinge directly above the bottom gate clip (5C).
4. Position the gate centered in the gate opening.
5. Attach bottom male hinge and slide up to meet bottom female hinge. Tighten securely (5C).
6. Attach top male hinge and slide down to meet top female hinge. Tighten securely (5B).
7. With an adjustable wrench, install the gate latch 36" from the ground (5A). Note: The gate latch can be
locked. Lock not provided.
5A 5B
5C
Step
4
Step
5

www.petsafe.net 7
Add Fence Fabric
1. Gather 5 Clips, 1 Tension Rod, package of Tie Wires, and the roll of Chain Link Fabric. Note: Putting on
the fabric is easy, except chain link fabric is strong and stiff and the roll is heavy, so a helper is recommended.
2. Start at a post next to the gate. Slip the tension rod down through the first diamonds of the fabric (6B).
3. Connect the fabric to the gatepost by clipping the tension rod to the post (6C). Secure all 5 clips.
4. Unroll the fabric around the kennel. Loosely add a tie wire to the top frame about every 5 feet to keep
the fabric from falling down (6A).
6A
6B
6C
__________________________________________________________________________________________________
Stretch the Fabric
1. Starting from the first post away from the gate, use a hammer to stretch
the fabric as shown.
2. Stretch fabric as tightly as possible. Add tie wires to posts to hold the
stretched fabric.
Important: Be sure all tie wires are on the same picket (wire) or
the fabric will be crooked.
3. Stretch and tie to the next post, until you go all the way around. Don’t tie
the last post (at the gate).
Step
6
Step
7

8 1-888-632-4453
Cut the Fabric
1. Gather 5 clips and 1 tension rod.
2. Stretch the fabric as tightly as possible to the last post and select a fabric
wire to cut, allowing 4 ½" for the tension rod and clips (8A).
3. Cut the fabric by holding the fabric loosely while you spin one of the pickets out.
a. Undo the knuckle at the top and the knuckle at the bottom of the
same picket (8B).
b. Unweave that picket by spinning it out (8C). Be careful! Wire ends
are sharp.
c. Install the tension rod (8D) and 5 clips (8E).
4 1/2"
Remove this picket
8A
8B 8C 8D
8E
________________________________________________________________________________________________
Secure the Fabric
Beginning at the gate opening, attach a tie wire to every 3rd diamond around the top
(9A) and every 5th diamond around the bottom (9B) of the kennel. Use any extra tie
wires around the bottom for extra security.
Note: Attaching tie wires around the bottom is easier if you temporarily raise the bottom of the kennel
onto bricks, blocks of wood, or the box that the kennel came in.
Important: Please, for your pets safety, train your pet to become accustomed to his
new home. Consult a professional for help.
9A
9B
Step
8
Step
9

www.petsafe.net 9
Caution
While this product is a solid barrier, Radio Systems®Corporation CANNOT guarantee that the system will, in all
cases, keep a pet within the established boundary. Not all pets can be trained for containment. Therefore, if you have
reason to believe that your pet may pose a danger to others or harm himself if he is not kept from exiting the product,
you should NOT rely solely upon the PetSafe®2-in-1 Dog Kennel to contain your pet. Radio Systems Corporation
shall NOT be liable for any property damage, economic loss or any consequential damages sustained as a result of any
animal exiting the system. If you are unsure whether this is appropriate for your pet, please consult your veterinarian
or certified trainer. This product is designed for use with pets only.
______________________________________________________________________________________________________
Terms of Use and Limitation of Liability
1. Terms of Use
This Product is offered to you conditioned upon your acceptance without modification of the terms, conditions and
notices contained herein. Usage of this Product implies acceptance of all such terms, conditions, and notices.
2. Proper Use
This Product is designed for use with pets where training is desired. The specific temperament of your pet may not
work with this Product. If you are unsure whether this is appropriate for your pet, please consult your veterinarian
or certified trainer.
3. No Unlawful or Prohibited Use
This Product is designed for use with pets only. This pet training device is not intended to harm, injure or provoke.
Using this Product in a way that is not intended could result in violation of Federal, State or local laws.
4. Limitation of Liability
In no event shall Radio Systems Corporation®be liable for any direct, indirect, punitive, incidental, special or
consequential damages, or any damages whatsoever arising out of or connected with the use or misuse of this
Product. Buyer assumes all risks and liability from the use of this Product.
5. Modification of Terms and Conditions
Radio Systems Corporation reserves the right to change the terms, conditions and notices under which this
Product is offered.

10 1-888-632-4453
Merci d’avoir choisi PetSafe®. Les liens qui vous unissent à votre animal de compagnie sont
notre priorité dans la conception de nos produits. Si vous avez des questions ou désirez nous
faire part de votre insatisfaction à l’égard d’un de nos produits, veuillez communiquer avec
le service à la clientèle au 1-888-632-4453, ou visitez notre site Web à l’adresse www.petsafe.
net.
_________________________________________________________________________________________________________
Table des matières
Pièces...................................................................................................................................................... 10
Outils nécessaires..................................................................................................................................... 10
Raccordez les barres ................................................................................................................................ 11
Ajout des piquets..................................................................................................................................... 11
Ajoutez un piquet pour le portillon.......................................................................................................... 12
Ajout de l’armature supérieure................................................................................................................. 13
Installation du portillon........................................................................................................................... 13
Pose du grillage ....................................................................................................................................... 14
Tension du grillage .................................................................................................................................. 14
Coupez le grillage.................................................................................................................................... 15
Fixation du grillage.................................................................................................................................. 15
Attention.....................................................................................................................................................
Conditions d’utilisation et limite de responsabilité........................................................................................
Français