Phonak Roger Pen Safety guide

How to Connect with
Roger Pen and EasyPen
General Operation
Device Description
1. On/Off/Mute
2. Connect
3. Indicator light (LED)
4. Microphone
5. Charging and audio input (micro-USB)
6. Slot for Roger Pen/EasyPen
7. Audio input (3.5mm/1/8 inch jack)
8. Charging input (micro-USB)
• To switch on, press the On/Off button on the side of the Roger Pen/EasyPen for 3 seconds.
• To switch off, press the press the On/Off button on the side of the Roger Pen/EasyPen for 3 seconds.
• To connect, hold your Roger Pen/EasyPen close (within 10 cm/4 inches) from the
Roger receiver. Then, press the connect button on your Roger Pen/EasyPen.
• When charging with the supplied USB power cord, the indicator light will shine solid green when fully charged.
2
1
3
4
5
6
8 7

Connecting to Computers/Tablets
1. Make sure you have switched on your Roger Pen/EasyPen.
2. Plug the rectangular end of the short audio cable into the bottom of your Roger Pen/EasyPen.
3. Plug the round end of the short audio cable into the headphone
output of your computer or portable device. Figure 1
4. Select “Headphones” from the pop up menu on your computer. Figure 2
5. Control volume by clicking on speaker icon on the bottom right corner of your computer screen. Figure 3
Figure 1 Figure 2 Figure 3