Phonak Roger TableMic II Safety guide

How to Connect with
Roger TableMic II
General Operation
Device Description
1. On/Off/ Mute
2. Microphones and indicator light
3. Audio input
4. Charging input
5. Connect
• To switch on, press the On/Off button on the side of the Roger
TableMic II until the indicator light turns green. Figure 1
• To connect, hold your Roger TableMic II close (within
10 cm/4 inches) from the Roger receiver.
• Press the connect button on your Roger TableMic II. Figure 2
• To switch off, press the On/Off button on the
side of the Roger TableMic II for 3 seconds.
• When charging with the supplied USB power cord,
the indicator lights will flash green. When fully
charged you will see a solid green light.
1
34
2
5
1s
Figure 1
Figure 2

Connecting to Computers/Tablets
1. Make sure you have switched on your Roger TableMic II.
2. Connect one end of the supplied audio cable into the aux-input of your TableMic II.
3. Connect the other end to the audio output of your computer or other audio source. Figure 3
4. Select “Headphones” from the pop up menu on your computer. Figure 4
5. Control volume by clicking on speaker icon on the bottom right corner of your computer screen. Figure 5
Figure 4
Figure 5
Figure 3