Pine Crafter Furniture 82 User manual

82, and 82F INSTRUCTIONS
CONTAINERS
#82 TWIN MATES BED (2 CARTONS TOTAL)
1 Box Twin HB/FB (Hardware: 8 – 80mm bed bolts, 8 – weld nuts and 1 – Hex Key)
1 Box (2) Cleated Rails (Hardware: 3 – twin bed wires and 6 – twin bed wires screws)
#82F FULL MATES BED (2 CARTONS TOTAL)
1 Box Full HB/FB (Hardware: 8 – 80mm bed bolts, 8 – weld nuts and 1 – Hex Key)
1 Box (2) Cleated Rails (Hardware: 3 – full bed wires and 6 – bed wire screws)
TOOLS REQUIRED
Phillips Screwdriver or Electric Drill
Hex Key (Provided)
ASSEMBLY INSTRUCTIONS
1. Check cartons to be sure all wooden parts and hardware is included.
2. To begin assembly, obtain headboard, footboard and two cleated rails.
3. Hold the HB upright and insert 80mm bed bolts through pre-drilled holes on HB and
metal brackets on rail and secure with weld nuts, as shown in Figure 1.
4. Repeat step 3 for the other side.
5. Attach FB to the other end using same method, as shown in steps 3 & 4.
6. Secure bed wires with bed wire screws to top of cleated rails, as shown in Figure 2.
Hardware – (Actual Size not Shown)
Hex Key
#82=1
#82F=1
80mm Bed Bolt and Weld Nut
#82=8
#82F=8
Bed Wire and 1” Screw
#82=3
#82F=3