Pine Crafter Furniture DB User manual

#DB INSTRUCTIONS
BOX CONTAINERS
1 Box (2) HB/FB (Hardware: 8 – 30mm Bed Bolts, 8 – Cap Nuts, 4 – 2-1/2” Wood Screws & 1 Hex Key
1 Box (1) Daybed Back Panel
1 Box (2) Cleated Rails ( Hardware: 3 – bed Wires and 6 – Bed Wire Screws)
TOOLS REQUIRES
Phillips Screwdriver or Electric Drill
Hex Key (provided)
ASSEMBLY INSTRUCTIONS
1. Check cartons to be sure all wooden parts and hardware is included.
2. To begin assembly, obtain HB/FB and two cleated rails.
3. Hold either HB or FB upright and insert 30mm bed bolts through holes on HB/FB and metal bracket on rail
and secure with cap nuts as shown in Figure 1.
4. Repeat step three for the other side.
5. Repeat steps 3 & 4 for other HB/FB as shown in Figure 2.
6. Obtain back panel and secure to backside of HB/FB (wood strip goes down) using four 2-1/2” wood screw
as shown in Figure 3. Make sure back panel is flush with top of HB/FB.
7. Secure bed wires with bed wire screws to rails as shown in Figure 4.
Hardware – (Actual Size not Shown)
Hex Key
DB=1
30mm Bed Bolt
DB=8
2 ½” Wood Screw
DB=4
Bed Wire and 1” Screw
DB=3