Pitney Bowes Datamax w1110 User manual

Right, let’s get your Network
Printer up and running quickly…
Let’s rst get together the things you will need:
• The box containing your Network Printer.
• A PC on which you have full admin rights to allow downloading
and installing software.
• 1 available USB port on your PC.
Continue reading below
Stand-Alone Network Printer
Read Now BEFORE you unpack your equipment
Microsoft Windows Installation Instruction
USB Printer Connection

1. Opening the box and unpacking.
Printer
USB Power Cord Network Cable
(not used for
USB installation)
Here’s a diagram and explanation of the items you should
nd in your box.
If you have any problems during this installation, refer to
‘Troubleshooting’.
2. Connecting the printer.
Connect the power cord and adapter to your printer
(as shown) and switch on.
3. Printer ready.
Wait for approximately 45 seconds until the green
light remains constant and the printer is ready.

4. Aligning the label roll.
Press the button and check that the label feeds out correctly.
Note: If the label does not feed correctly please refer to label
alignment instructions inside the printer top cover.
Tear o the correctly dispensed label.
5. Connecting the printer and
driver download.
Connect your printer to your computer with the USB cable.
Your Printer Driver should automatically download and
install. If this does not happen, please follow step 6 below.
Otherwise continue to step 7.
6. Manually download the
printer driver.
1. Go to support.pb.com/workstation
2. Select Download Drivers for Workstation w1110 Label
Printer in the Downloads section.
3. Select in the Download your Windows printer
driver section.
4. Select Run or Open dependant on your browser.
5. Accept the licence agreement and follow the on screen
prompts to install.
6. Select Datamax-O’Neil w1110.
7. Continue to follow the on-screen prompts and click
Finish/ Close.
Note: You may need to check your downloads folder to install
Printer Drivers.

7. Test print.
Your printer is now connected.
To test your printer is working correctly follow the steps
below.
On a PC
Go to your Control Panel
Select Devices & Printers
Double click on the Printer
(DataMax-O’Neil w1110)
Note: If DataMax O’Neil w1110 is not available please
manually download your printer driver as in step 6.
1. Select Printer from the menu bar
2. Select Properties
3. Select General
4. Select Print Test Page.
Check that your label has printed correctly. If you have any
issues with the print refer to Troubleshooting later in this
document.
Troubleshooting
Printing problems on Datamax w1110
If you experience problems with a Datamax w1110 printer, such
as poor print quality, misaligned labels, jams, or ashing LED
indicator lights, ensure that the roll is properly installed in the
printer.
If the labels are blank, the roll may be loaded upside down.
The two green brackets in the Datamax printer are spring loaded
to keep the roll in place. Slide the green brackets apart to place
the roll between them with the adhesive labels on the top and the
disposable material on the bottom.
If you’re still having trouble, then visit
support.pb.com/workstation
and select Errors & Troubleshooting.
*AW32661reva*
3001 Summer St.
Stamford, CT 06926
www.pitneybowes.com
AW32661 Rev. A 05/18
©2018 Pitney Bowes Inc.
All Rights Reserved