Planet DVR-460 User manual

4-CH MPEG-4 Digital Video Recorder
DVR-460
Quick Installation Guide

Table of Contents
1. Overview ................................................................................................ 3
2. Package Contents ........................................................................................ 4
3. HDD Installation .......................................................................................... 5
4. Hardware Installation ................................................................................... 7

3
1. Overview
This quick installation guide describes the objectives, organization and basic
installation of the PLANET DVR-460 surveillance system, and offers standalone
system to build a distributed surveillance system, which can be monitored over the
Internet, and equipped with Hard Disc Drive that records the video directly. Also,
this guide shows you how to nd additional information on related products and
services.

4
2. Package Contents
DVR-460
Power adapter
Power cord
Quick installation guide
User’s manual CD
DSUB PIN connector
Flat cable clamp
Remote controller
IR receiver
Screws
Note
If any of above items are missing or damaged, please contact your
local dealer for support.
ó
ó
ó
ó
ó
ó
ó
ó
ó
ó

5
3. HDD Installation
Note
The HDD must be installed before the DVR is turned on.
Step1: Loose the screws on the upper cover and open the upper cover of the
DVR.
Step2: Remove the HDD bracket.
Step3: Get a compatible SATA HDD, and connect it to the power connector
and data bus connector (make sure to align the HDD precisely for pin
connection).

6
Step4: Screw the HDD onto the HDD bracket (Two screws for each side), and
then screw the HDD bracket back to the DVR base.
Step5: Close the upper cover of the DVR, and fasten all the screws you loosened
in Step 1.

7
4. Hardware Installation
1. Please connect your cameras to the Video Input (1~4).
2. Connect your monitor to “Monitor” connector.
3. Connect the LAN port to your switch/hub with a RJ-45 cable.
4. Connect IR reciver to the “IR” connector.
5. Connect the bundle power to the power connector (DC 19V).
6. Press power button to turn on your DVR-460.
Further conguration and information can be found in the user’s manual CD. Please
check the user’s manual for more understanding.

This page is intentionally left blank