Point Mobile PM30 User manual

Quick Start Guide
V 2.0, Mar 2021
Copyright © 2021 Point Mobile Co., Ltd. All rights reserved.
Point Mobile Co., Ltd. is the designer and manufacturer of mobile handheld devices.
The Point Mobile logo is a registered trademark and symbol of Point Mobile Co., Ltd.
Features and specifications are subject to change without prior notice.
PM30

Device Parts
1. Front camera
2. Receiver
3. Screen
4. Back button
5. Home button
6. Recent app button
7
12
7. Speaker
8. Push-To-Talk (Default)
/ Scan button (Programmable)
9. Volume up & down button
10. LED Indicator & Sensor
11. Scanner
12. Microphone (Second)
5
6
4
8
9
3
1
11
2
10

Device Parts
1. Fingerprint sensor
2. Flashlight
3. Rear camera
4. I/O connector for sled accessory (RF300, Gun handle)
5. I/O connector for cradle charging
6. USB Connector
7. Microphone (Main)
8. Power button
9. Scan button
10. Card tray
6
4
5
1
10
8
9
2
3
7

Product Standard Accessories
Country plug
AC/DC power supply USB type C cable
LCD protection film
Product Optional Accessories
Dual slot cradle
Protective case
PM Booster
(Extended battery case)
Gun handle
Wireless charging pad
Single slot cradle
(for RF300 or gun handle)
RF300
(UHF RFID reader)
SIM tray eject pin

Install SIM, SD card
PM30 supports nano SIM and microSD card. (nano SIM card
is supported by LTE SKU only.)
1. Insert and push the card tray eject pin into the hole of
card tray. And pull the tray out.
Turn on / off PM30
Turn on
Turn off
Press and hold the Power button on the right side of
PM30 until SMART BEYOND RUGGED logo displays on
the screen.
When the screen is on, press and hold the Power button
until the power menu is shown.
Then, tap Power off among the menu.
2. Insert the nano SIM card and microSD card into proper
slot in the correct orientation.
(Gold contact must be facing down.)

Charging the Device
1. Assemble the AC/DC power supply, country plug and
USB type C cable
2. Connect the USB type C cable to PM30
3. Provide power by plugging the power supply to the
wall socket
< Caution >
1. Always use an original power supply from Point Mobile.
Other chargers and cables may damage the PM30.
The device warranty does not cover any damage caused by
the usage of non-original power supplies.
2. Make sure the charger and cable is not wet.
LED Indicator
1
2
No
Indicator
Status
Indication
1
Power
LED
Solid
red
Charging
the device (With charger)
/
Battery is low (Without charger)
Blinking
red
Battery
is critical low
Solid
green
Device
is fully charged
2
Notification
LED
Blinking
blue
Notification
existing
Red
flash
Barcode
reading failed
Blue
flash
Barcode
reading success

Scan a Barcode
Scanner is placed on the top of the PM30. Scanner is
disabled by default, so enable the scanner from ScanSettings
first. Then, press the scan button to scan a barcode.
Place the barcode within
the the green dot aimer.
Keep distance that the
green dot aimer can cover
the barcode enough.
Certification
Model: PM30
Trade name of certified: Point Mobile Co. Ltd.
Manufacturer: Point Mobile
For more certificate Information,
go Settings >About phone >Certificates
Scan button
Scanner