StairClimber™ (SCL) 800
Assembly Guide
ASSEMBLY REQUIREMENTS
Follow the steps in the order listed in this assembly guide.
Precor requires at least two people to assemble the equipment. DO NOT attempt assembly by yourself.
IMPORTANT Before you fully tighten a fastener, check that its head is flush with the surface of the equipment. If not, cross-threading may have occurred. DO NOT attempt to rework the assembly as
more damage to the equipment will occur. Instead, contact Customer Service at www.precor.com.
We recommend you:
lAssemble the equipment close to where you plan to use it.
lAssemble the equipment on a solid, flat surface, so that it remains level and stable.
lLocate the equipment at least 24 inches (0.6 meter) away from walls or furniture on either side of the equipment, and 24 inches (0.6 meter) away from objects behind or in front of the equipment.
lThe equipment needs minimum ceiling height of 9' 9" feet (3 meters).
lDO NOT move the equipment without assistance.
Required Tools
5/32-inch hex wrench 7/32-inch hex wrench or socket 1/2-inch wrench
HARDWARE KIT
Image Hardware Qty Parts Qty
5/16-18 x 1-inch bolt with washer 4 Right handlebar 1
1/4-20 x 5/32-inch flat head socket cap screw - USE
FOR CONSOLE MOUNTING ONLY. 4 Left handle bar 1
3/8-16 x 7/32-inch button head cap screw black 8 Center mast 1
Lower handlebar cover 4
Wire callouts
Gasket 1 Right handlebar built-in Stop wire
Gasket cover 1 Left handlebar built-in heart rate and speed
control wires
O ring pre-installed on the handlebars 2
INSTALL CENTER MAST
IMPORTANT During the center mast assembly ensure the wires are completely stretched out and will not fall back into the center mast.
©2021 Precor Incorporated. PN 306314-101 ENU, 24 March 2021.
