Pro-gard Products LLC. B5802EXPD18 User manual

pro-gard.com
800.480.6680
INSTALLATION GUIDE
Released 01.05.2019
B5802EXPD18 & B5805EXPD18
CARGO BARRIER
2018+
FORD EXPEDITION

2
pro-gard.com
800.480.6680
I. The following tools will be required to complete the installaon
A. Ratchet with 7/16” Socket
B. #2 Phillips Screwdriver
II. Read all instrucons and refer to last page to ensure all parts were received
W ARNING :
Locate All wiring, fuel lines, brake lines, coolant lines, or refrigerant lines before
drilling any holes or installing any self-drilling fasteners.
III. Barrier Installaon
A. Install the upper mounng brackets (3B5818-02D driver’s
side, and 3B5818-02P passenger side) nger ght to the top
of the barrier using a (3X36) carriage bolt and (3X16Z) whiz
nut on each side. The deep bend on the brackets should
face away from the barrier and project in the downward
direcon (see Fig. 1).
B. Remove the OEM coat hook assemblies from the headliner
area near the rear hatch.
C. Place the barrier in place behind the rear seats. With the
second row seats folded down, raise the barrier up and align
the rear of the upper support brackets with the holes from
the OEM coat hooks. Insert the (4S5070P7) spacer between
the bracket and coat hook hole, pass the (3X262) bolt
through the bracket and spacer, and loosely thread it into the coat hook hole (do this for both sides).
D. Loosen the rear seat bolts at the base of the 2nd row seats and insert the forked end of the (3B5818-01) lower barri-
er brackets. Align the holes in the rear of the brackets with each side of the barrier, and fasten with two (3X36) car-
riage bolts and two (3X-16Z) whiz nuts at each end (See Fig 2).
THESE COMPONENTS ARE REQUIRED
TO INSTALL THE CARGO BARRIER
3B300X BARRIER
Part #4B58EXPD18 HARD-
WARE/WING KIT
3B5818-02P
Fig. 1

3
pro-gard.com
800.480.6680
IV. Install Wings
A. Aach the polycarbonate top panel (3BW5818-05) to the barrier using the exisng bolts from the top of the barrier
window frame. Hand ghten fasteners.
B. Aach polycarbonate lower wings (3BW5818-03 and 3BW5818-04) to each side using two (3X36) carriage boots and
two (3X16Z) whiz nuts on each. H and ghten fasteners.
C. Aach polycarbonate upper wings (3BW5818-01 and 3BW5818-02) to each side using exisng barrier window hard-
ware. Hand ghten fasteners.
D. Posion the barrier in the center of the vehicle. Adjust the polycarbonate wings for desired t against the interior
trim and headliner. Tighten all fasteners.
E. Installaon is now complete.
3B5818-01
3X36
Fig. 2
(Driver’s Side Shown)

4
pro-gard.com
800.480.6680