Promate Steer User manual

Steer
User Guide
100 hrs Standby
Working Time
Noise
Suppression
Dynamic Bluetooth®v4.0 Mono Headset
Ergonomic

Introducon
Music either rock or romanc, wouldn’t be any beer without Steer, an ultra-light-
weight Bluetooth® v4.0 mono headset. It is among those rare headsets that gives
you crystal clear sound in addion to being extremely trendy. It supports up to 5
hours of talk me and around 100 hours of stand-by me! Impossible it sounds,
but these features are truly available in this amazing Bluetooth® Headset. What
makes the Headset almost priceless is its high number of useful features. It allows
you to accept / reject the incoming calls, redialing, voice-dialing, end calls and also
increase / decrease the volume while listening to music on your mobile. It features
up to a radius of 10 meters from your smartphone. All these features make steer a
clear winner for audiophiles.
Packaging Content
• Steer
• Carry Pouch
• Ear bud
• Charging cable
• User Guide
Specificaon:
• Bluetooth® Version: v4.0
• Bluetooth® Profile: HFP, HSP, A2DP, AVRCP
• Charging Input Power: 5V/500mA
• Impedance: 32Ω
• Speaker Frequency: 50Hz-2.8kHz
• Baery Capacity: 65 mAh
• Charging me: 2-3 hours
• Maximum playing hours: 5 hours
• Standby me: 100 hours
• Operang Distance: 10 meters
1

Features:
• Bluetooth® 4.0 Mono wireless headset
• Slim and elegant design
• Comfortable Padded Ear Buds
• Built-in Controls
Compability:
Steer may be paired as a headset to any compable Bluetooth® enabled devices.
Precauons
Please read all safety instrucons and warnings thoroughly before using this product.
Improper use of this product may result in damage to this or aached products. To
keep the product working at its opmum performance, never use it in the following
condions:
1. Moist or underwater condions.
2. Condions near the heater or high-temperature service.
3. Condions with direct sunshine.
4. Never dismantle the product without due permission, else this may nullify
warranty clauses.
2

Appearance & Interface Descripon:
1. Receiver
2. Volume (-) Buon
3. Mul-Funcon Buon
4. Volume (+) Buon
5. LED indicator
6. Micro-USB charging port
7. MIC
3
1
2
3
7
4
5
6

Operaon Instrucons:
1. Turning the Steer On/Off
• To power on: press and hold mulfuncon buon for about 3 seconds unl
green light flashes
• To power off: press and hold mulfuncon buon for about 6 seconds unl
indicator light goes off
2. Pairing Steer with your Bluetooth® device
You are required to pair Steer with your smartphone once before using it.
• Press and hold the Mul-funcon buon for 6 seconds unl the green LED
and red LED start flashing alternately to enter pairing mode.
• Acvate Bluetooth® on your mobile phone.
• Set your phone to discover ‘Steer’ and follow the instrucons.
• If your phone asks for a passkey or PIN code, confirm with ‘0000’ (4 zeroes).
When the phone and Steer are paired and connected, green LED starts
flashing.
4

3. Pairing Steer with a second Bluetooth device(Mulpoint Pairing):
• Restart Steer. Press and hold the Mul-funcon buon for 6 seconds unl
the green LED and red LED start flashing alternately to enter pairing mode.
• Acvate Bluetooth® on both your smart phones.
• Set your 1st phone to discover "Steer" and follow the instrucons to pair
with the device.
• Find "Steer" in the second device and pair again.
• Two bluetooth device both connected now.
• If your phone asks for a passkey or PIN code, confirm with ‘0000’ (4 zeroes).
When the phone and Steer are paired and connected, green LED starts
flashing.
4. Answering a call:
• With one phone connected
•Short press any buon once to answer an incoming call.
• With two phones connected
•Short press Mul-Funcon buon once to answer an incoming call.
•When you are on first phone and a call is coming on the second phone, press
mul-funcon buon twice to keep the first call on hold and answer the
second call. Press the mul-funcon buon once to end the second
phone call and connue the first call.
• Press and hold the Mul-funcon buon for two seconds during the first call to
reject the second call.
• Short press the Mul-funcon buon once to end the first call and answer the second call.
5

3. Pairing Steer with a second Bluetooth device(Mulpoint Pairing):
• Restart Steer. Press and hold the Mul-funcon buon for 6 seconds unl
the green LED and red LED start flashing alternately to enter pairing mode.
• Acvate Bluetooth® on both your smart phones.
• Set your 1st phone to discover "Steer" and follow the instrucons to pair
with the device.
• Find "Steer" in the second device and pair again.
• Two bluetooth device both connected now.
• If your phone asks for a passkey or PIN code, confirm with ‘0000’ (4 zeroes).
When the phone and Steer are paired and connected, green LED starts
flashing.
4. Answering a call:
• With one phone connected
•Short press any buon once to answer an incoming call.
• With two phones connected
•Short press Mul-Funcon buon once to answer an incoming call.
•When you are on first phone and a call is coming on the second phone, press
mul-funcon buon twice to keep the first call on hold and answer the
second call. Press the mul-funcon buon once to end the second
phone call and connue the first call.
• Press and hold the Mul-funcon buon for two seconds during the first call to
reject the second call.
• Short press the Mul-funcon buon once to end the first call and answer the second call.
5. Rejecng a call:
• Press and hold the Mul-Funcon buon for 2 seconds to reject a call.
6. Using the Last number Re-Dialing feature
• Short press Mul-Funcon buon twice to re-dial the last dialed number.
7. Adjusng the volume of the headset and controlling music playback
• Press the volume (+) buon to increase the volume. Long press (-) to go to the next song.
• Press the volume (-) buon to decrease the volume. Long press (+) to go to
the previous song.
8. Charging the Steer
Charging using the Micro-USB cable. Connect the Micro-USB connector to
the charging port of the Steer to start charging the Bluetooth® device.
The LED is lit up in red while charging and LED will be green when charging is
done.
6