Pyxis LS-200 Troubleshooting guide

1
LS-200 Quick Start-up Guide
Tools Need for Installation
Mobile phone with IOS or Android (not included)
Power Cable (Included)
LS-200 Wiring
Follow the wiring table below to connect the LS-202 sensor’s 4-20mA output to a controller and power
supply.
LS-200 Indicator
The indicators on the top of the sensor (figure 3) are used to indicate power status and Bluetooth
connection status.
LED Status
ON
OFF
Green Led
Power Supply is on
Power Supply is off
Blue Led
Bluetooth is connected
Bluetooth is disconnected

2
Set up using uPyxis Mobile App
Download uPyxis Mobile App from Apple App Store or Google Play.

3
Connecting to uPyxis Mobile App
Turn on Bluetooth on your mobile phone (Do not pair the phone Bluetooth to the LS-200). Open uPyxis
Mobile App. Once the app is open the app will start to search for the sensor. When the uPyxis App
connects to the sensor then press on the LS-200 Sensor Picture.
When connected, Mobile App will default to the Overview screen. Second figure below reference
parameters for tank. To enter the setting press on Setting tab.

4
In the Setting screen, you can set the Level Sensor Settings by renaming the Device Name. The
Sampling Mode can be changed to your preference. To configure the tank, enter the settings by
pressing on Tank Volume,Installation Height,Max Level, and Display Units.Note: Max Level Height
must be 4 inches less then Installation Height. To save the settings, press Apply Settings.
To save the setting, press on Set Device. The LS-200 also has password protect capabilities. To
password protect the setting on Password, press on Set.After press Set, the screen will change over to
the Set Password screen. Before setting a new password, contact Pyxis Service Department and give
them the code at the bottom of the screen. The service representative will provide you with a
password. Enter the password that was giving in the Original Password box. Then enter the New
Password, Confirm Password, and press Set Password.

5
To verify your readings after setting your parameters click on Reading.
For more information on the Installation Process reference LS-200 Operation Manual.