Raven AccuBoom User manual

AccuBoom™ Installation Manual
CaseIH SPX3310

Notes:

Manual # 016-0171-004
1
CHAPTER
I NTRODUCTION
Congratulations on your purchase of the Raven AccuBoom system! This
system is designed to provide worry free turn-on and turn-off of your
booms with respect to the as-applied coverage map. The following
instructions are designed to assist you in the proper installation of the
AccuBoom system. See the Viper Installation and Operators Manual for
instructions on setting up the software and using the AccuBoom system.
You will also need a valid AccuBoom Control Activation Key for your
Viper system in order to activate the AccuBoom system.
Components
Needed
• Previously installed CASE SPX3310 AccuBoom System
• AccuBoom SPX3310 AIM Extension Cable – P/N 063-0171-577
Important! All boom switches must remain in
the ON position while AccuBoom control is in
operation!

Case IH SPX3310 AccuBoom AIM Control Extension Cable Installation and Operators Manual
2
Notes:

Manual # 016-0171-004
3
CHAPTER
AIM E XTENSION C ABLE I NSTALLATION
1. Install the CAN AccuBoom node and SPX3310 CAN AccuBoom cable
(P/N 115-0171-553) according to the instructions provided with the
CAN AccuBoom cable.
2. Connect the Raven AIM Command cable to the AccuBoom cable:
a. Remove the cap from the 6 pin Deutsch AIM Command connector
on the CAN AccuBoom cable (P/N 115-0171-553).
b. Attach the optional Raven SPX3310 AIM Command cable
(P/N 115-0171-577) to the 6 pin Deutsch connector on the CAN
AccuBoom cable.
Right Boom Connector
Mount CAN Accuboom Node Here
AIM Extension
Connector

Case IH SPX3310 AccuBoom AIM Control Extension Cable Installation and Operators Manual
4
3. Route the Raven AIM Command cable (P/N 115-0171-577) up to and
into the cab.
4. Remove the side panel cover to gain access to the wiring.

Manual # 016-0171-004
5
5. Disconnect the AIM Command cable from the control system:
a. Locate the Case AIM Command Tee cable in the side access
panel. These will be 6 pin Weatherpack connectors.
b. Disconnect the Case AIM Command Tee cable from the boom
shutoff sense connectors.
c. Connect the two ends of the system harness back together.
6. Connect AccuBoom to the AIM Command:
a. Connect the optional SPX3310 Raven AIM Command cable
(P/N 115-0171-577) to the AIM Command Tee cable.
b. Connect the supplied tee cap to the other end of the Case AIM
Command cable.
7. Replace the side panel cover.
8. The AIM Command module will now be controlled by the Raven CAN
AccuBoom system.
AIM Command Tee

Raven Industries will not assume any expense or liability for repairs
made outside our facilities without written consent. Raven Industries
is not responsible for damage to any associated equipment or
products and will not be liable for loss of profit or other special
damages. The obligation of this warranty is in lieu of all other
warranties, expressed or implied, and no person or organization is
authorized to assume any liability for Raven Industries.
Damages caused by normal wear and tear, misuse, abuse, neglect,
accident, or improper installation and maintenance are not covered
by this warranty.
What Does this Warranty Cover?
How Long is the Coverage Period?
How Can I Get Service?
What Will Raven Industries Do?
What is not Covered by this Warranty?
Bring the defective part and proof of purchase to your Raven Dealer.
If your Dealer agrees with the warranty claim, the Dealer will send the
part and proof of purchase to their distributor or to Raven Industries
for final approval.
Upon confirmation of the warranty claim, Raven Industries will, at our
discretion, repair or replace the defective part and pay for return
freight.
RAVENINDUSTRIES
Limited Warranty
This warranty covers all defects in workmanship or materials in your
Raven Applied Technology Product under normal use, maintenance,
and service.
Raven Applied Technology Products are covered by this warranty for
12 months after the date of purchase. This warranty coverage applies
only to the original owner and is nontransferable.

Notice: This document and the information provided are the property of Raven Industries, Inc. and may only be used as authorized
by Raven Industries, Inc. All rights reserved under copyright laws.
CaseIH SPX3310
AccuBoom™ Installation Manual
(P/N 016-0171-004 Rev A 3/09)
Raven Industries Toll Free (U.S. and Canada): (800)-243-5435
Applied Technology Division or Outside the U.S. :1 605-575-0722
P.O. Box 5107 Fax: [phone]
Sioux Falls, SD 57117-5107 www.ravenprecision.com
[email protected]