Razor W13112130043 Use and care manual

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
1
WARNING
Step 1 Step 2
Required Tools: (Not included)
A. Flathead screwdriver
B. 5 mm Allen wrench
C. 3 mm Allen wrench
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect
charger before conducting any assembly or maintenance procedures. Failure to follow these
steps in the correct order may cause irreparable damage.
Using a 5 mm Allen wrench loosen up the bolts from the
collar clamp and remove the t-bar.
Disconnect the throttle from the controller.
BLACK LABEL E90™/BLACK LABEL E100™
THROTTLE REPLACEMENT
PART # W13112130043

Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00am - 5:00pm Pacific Time.
2
Step 3 Step 4
Step 5 Step 6
Step 7
Slide the throttle out the handlebar and carefully pull
the wire.
Using a flathead screwdriver remove the plastic end cap
from the handle. Set end cap aside.
Using soapy water or some lubricant apply some drops
in between the handle and the grip and remove the grip.
Set grip aside.
Using a 3 mm Allen wrench loosen up the set screw at the
bottom of the throttle.
Reverse the steps to install.
ATTENTION: Charge battery 12 hours before using.