real living GREY SWIVEL CHAIR HG-4301-1 User manual

Read all instructions before starting
Clear a flat covered space to assemble
We recommend two people for assembly.
Note that hardware required is provided for every step
Pay attention to orientation
Letter of the part corresponds to a sticker on the product
Number of the hardware corresponds to its number in the package
Helpful hints provided along the way
Regularly check hardware and tighten if necessary
GENERAL BEST PRACTICES FOR ASSEMBLY:
MAINTENANCE:
CARE AND CLEANING:
Clean periodically by wiping the product with a soft clean cloth
DO NOT use abrasive chemicals for cleaning.
WARNING:
DO NOT use power tools.
DO NOT exceed maximum weight capacity of 225lbs(102kg).
DO NOT stand or step on this chair.
DO NOT use this chair unless all bolts,screws and knobs are firmly secured.
Use for seating only one person at a time.

x5
CASTOR
x1
BASE
x1
GAS LIFT
x1
SEAT CUSHION
x1
BACK CUSHION
x1
SEAT PLATE
x1
BACK BAR
A
BC
F
D E
PARTS LIST
G

x4
SCREWS
x2
SCREWS
x4
SCREWS
13
HARDWARE LIST
2
x1
ALLEN
WRENCH

Insert the part (A) into part (B ) as shown.
STEP 1
STEP 2
Insert part (C) into the center hole of part (B) as shown in the diagram.

x4 x1
STEP 3
Align the holes in part (D) with the holes in part (F). Using screws (1)
and Allen Wrench (4), attach part (F) to part (D) as shown in the
diagram. Fully tighten all screws.

Align the holes in part (G) with the holes in part (E). Using screws (3) and
Allen Wrench (4), attach part (G) to part (E) as shown in the diagram.
Fully tighten all screws.
STEP 4
x2x1

STEP 5
x4x1
Align the holes in part (G) with the holes in part (D). Using screws (2)
and Allen Wrench (4), attach part (G) to part (D) as shown in the
diagram. Fully tighten all screws.

STEP 6
Align the center hole of part (F) with the top of part (C) and press firmly into
place. Assembly is now complete. Use the lever to raise and lower the seat
as desired.