Rear view safety RVS-5350-W User manual

1
TM

What’s in the Box?
REAR VIEW SAFETY
2
5.3 Cable connection instruction
Monitor
icense plate camera with built in sensors
2 - Wireless transmitters with RCA connections.
4 pin Camera input with sensor speaker attached
Congratulations on purchasing a Rear View Backup
Camera System. With this manual you will be able to
properly install and operate the unit.
To insure the best performance and avoid any false alarm
or function failure, please read this manual carefully and
install it accordingly.
TO OUR OYA CUSTOMERS:
Packing list:
Note:
Before installing system let the components of the exhaust system cool down. This will make the
installation safer and preclude heat damage to the backup sensor wiring or components.

3
Installation Instructions
Reverse Wi h Confidence™
Red to ba k light +12
Red to ba k light +12
Bla k to GND
Bla k to GND
5.4 Installation Instructions:
Monitor:
- Attach the monitor to the dash with the 3M
sticker.
- Connect the wireless transmitter to the YE OW
RCA input labeled AV2 and connect the power wires
on both the monitor and the transmitter to a 12V
power source.
Camera:
- Use a screwdriver to remove the screws of the
licence plate. ine up the screw holes on the camera
with the holes on the license plate and attach the
camera using the license plate screws.
- Plug the anti-dismounting cap into the screw
hole.
Wireless re eiver Wireless transmitter

REAR VIEW SAFETY
4
Installation Instructions
- Connect the 4 pin connection on the camera to the 4 pin connection on the camera wiring
harness.
- Attach the wireless transmitter to the YE OW RCA port labeled AV-OUT.
- Connect both the camera and the transmitter to a 12V power source from the reverse lights.
NOTE:
When connecting the power wires, connect the RED to power and the B ACK to ground.
3. Align the host bracket screw groove and the
plate screw holes, ocking screw.
4. Plug the anti dismounting cap into the screw
hole. Connect the cable.
5.5 Display Installation
Monitor Rearview mirror monitor
Red to ba k light +12
Red to ba k light +12
Bla k to GND
Bla k to GND
Wireless re eiver Wireless transmitter

5
Reverse Wi h Confidence™
Installation Instructions
Tools Needed
Small flat-tip Screwdriver #2 Phillips Screwdriver Tape Measure
Black Electrical Tape Masking Tape Multimeter
Pliers Pencil/Marker
Testing the system:
After installing the system, test the sensors.
Warning:
Do not stand behind a moving vehicle death or injury could occur. Prior to testing, set the
parking brake on, ignition key on (do not start), step foot on brake and shift the vehicle into
reverse. Ensure that the engine is not running while proceeding with the following tests:
Test the system operation with a large object (piece of wood (60*30*1cm) or other
object (not too small). Start with the object more than 1m away from the vehicle.
Then move the object closer the vehicle and ensure that the buzzer, ED, and distance
indicators display correctly.

REAR VIEW SAFETY
6
Specifications
Awareness
Safe mode
Alarm mode
Dange mode
Alarm mode
Dange mode
Distan e
130-150 m
90-130 m
60-90 m
40-60 m
0-40 m
Sound
Bi...Bi...
Bi..Bi..
Bi.Bi.
BiBi
Biiii
Digital Display
1.3m-1.5m
0.9m-1.3m
0.6m-0.9m
0.4m-0.6m
0.0m
Control box
Sensors Camera Sensors
Operating voltage
Operating urrent
Dete ting distan e
Camera Angle
Ultrasoni frequen y
Working temperature
Store temperature
DC9~16V
40KHz
0.3~1.50m
120 degree
-20°C ~ 85°C
-30°C ~ 85°C
≤150mA
Specifications
Alarm MODE

7
Reverse Wi h Confidence™
imitations
If the vehicle is equipped with
high-power radio antenna.
If another vehicle bumper is too high
When backing up downhill If there is a very small object.
The rear 45° oblique to the obstacle If there is a wire fence.
Backing up in heavy rain or snow. If it’s a smooth slope
If is smooth round object Objects absorbing wave, e.g. Cotton
The sensors may not work if an object does not reflect the ultrasonic waves or it has an unusual
shape. This may apply to a pole, cardboard carton, bicycle tire, small or slender tree or a low curb.
The sensor may not detect another vehicle bumper if it is too high.
Also note: This system has different detection distance to different objects. To a wall, the max de-
tection distance is 1.8m. To the human body, the max detection distance is 1.0m. In some special
cases, the display may not be the same as the real condition due to the sensor position,
obstacle shape, reflection condition and so on. Some examples are given below:
imitations:

REAR VIEW SAFETY
8
Troubleshooting
No buzzer or display at power up.
1. Is power wire connected to control unit correctly?
2. Verify(+)12V at control unit when vehicle is in reverse.
3. Verify the ground connection.
4. Have you connected to the correct reversing indicator wire?
5. Do you have a minimum of (+)12V and ground at the display?
No reverse image.
1. Is the connection of camera power cable and AV cable are right or not?
2. Is AV cable connected to AV2?
Guarantee time:12 months.
The guarantee will be effective with the stamp/signature of the dealer.
Please keep the guarantee form well to ensure 12 months guarantee.
Troubleshooting:

9
Reverse Wi h Confidence™
Warranty
One Year Warranty
Rear View Safety, Inc. warrants this product against material defects for a
period of one year from date of purchase. We reserve the right to repair or
replace any such defective unit at our sole discretion. Rear View Safety, Inc.
is not responsible for a defect in the system as a result of misuse, improper
installation, damage or mishandling of the electronic components. Rear View
Safety, Inc. is not responsible for consequential damages of any kind.
This warranty is void if: defects in materials or workmanship or damages re-
sult from repairs or alterations which have been made or attempted by oth-
ers or the unauthorized use of nonconforming parts; the damage is due to
normal wear and tear, this damage is due to abuse, improper maintenance,
neglect or accident; or the damage is due to use of the Rear View Safety,
Inc. system after partial failure or use with improper accessories.
Warranty Performance
DURING THE ABOVE WARRANTY PERIOD, SHOU D YOUR REAR VIEW SAFETY
PRODUCT EXHIBIT A DEFECT IN MATERIA OR WORKMANSHIP, SUCH DEFECT
WI BE REPAIRED WHEN THE COMP ETE REAR VIEW SAFETY, INC. PRODUCT
IS RETURNED, POSTAGE PREPAID AND INSURED, TO REAR VIEW SAFETY, INC.
OTHER THAN THE POSTAGE AND INSURANCE REQUIREMENT, NO CHARGE
WI BE MADE FOR REPAIRS COVERED BY THIS WARRANTY.
Warranty Disclaimers
NO WARRANTY, ORA OR WRITTEN, EXPRESSED OR IMP IED, OTHER THE
ABOVE WARRANTY IS MADE WITH REGARD TO THIS REAR VIEW SAFETY, INC.
REAR VIEW SAFETY, INC. DISC AIMS ANY IMP IED WARRANTY OR MERCHANT-
ABI ITY OR FITNESS FOR A PARTICU AR USE OR PURPOSE AND A OTHER
WARRANTIES IN NO EVENT SHA REAR VIEW SAFETY. INC. IAB E FOR ANY
INCIDENTA , SPECIA , CONSEQUENTIA , OR PUNITIVE DAMAGES OR FOR ANY
COSTS, ATTORNEY FEES, EXPENSES, OSSES OR DE AYS A EGED TO BE AS A
CONSEQUENCE OF ANY DAMAGE TO, FAI URE OF, OR DEFECT IN ANY PROD-
UCT INC UDING, BUT NOT IMITED TO, ANY C AIMS FOR OSS OF PROFITS.

REAR VIEW SAFETY
10
Disclaimer
Rear View Safety and/or its affiliates does not guarantee or promise
that the user of our systems will not be in/part of an accident or
otherwise not collide with an object and/or person. Our systems are
not a substitute for careful and cautious driving or for the consistent
adherence to all applicable traffic laws and motor vehicle safety
regulations. The Rear View Safety products are not a substitute for
rearview mirrors or for any other motor vehicle equipment mandated
by law. Our camera systems have a limited field of vision and do not
provide a comprehensive view of the rear or side area of the vehicle.
Always make sure to look around your vehicle and use your mirrors
to confirm rearward clearance and that your vehicle can maneuver
safely. Rear View Safety and/or its affiliates shall have no responsi-
bility or liability for damage and/or injury resulting from accidents
occurring with vehicles having some of Rear View Safety products
installed and Rear View Safety and/or its affiliates, the manufacturer,
distributor and seller shall not be liable for any injury, loss or
damage, incidental or consequential, arising out of the use or
intended use of the product. In no event shall Rear View Safety
and/or its affiliates have any liability for any losses (whether direct
or indirect, in contract, tort or otherwise) incurred in connection
with the systems, including but not limited to damaged property,
personal injury and/or loss of life. Neither shall Rear View Safety
and/or its affiliates have any responsibility for any decision, action
or inaction taken by any person in reliance on Rear View Safety
systems, or for any delays, inaccuracies and/or errors in connection
with our systems functions.

11
Reverse Wi h Confidence™

If you have any questions
about this produ t, onta t:
Rear View Safety, In .
1797 Atlanti Avenue
Brooklyn, NY 11233
800.764.1028
BETTER CAMERAS. BETTER SERVICE.
IT’S OUR GUARANTEE.