5
1785069 Rev X
ECO 15-0005
May 2015
Owner’s Manual: 1400 and 1410
Classic Shaker
1.2 Safety Precaution Summary
...Safety Information, continued
WARNING!
DO NOT attempt to replace any damaged
electrical wire or components. Improper
replacement could result in electric shock and
serious injury. Only a qualified service
representative should attempt to repair or replace
any damaged electrical components.
Review this owner's manual before installing or
operating.
The machine must be properly grounded prior
to use. In the case of an electrical short circuit,
grounding reduces the risk of electric shock by
providing an escape wire for the electric current.
The machine’s power cord has a grounding wire
with an appropriate grounding plug. This plug must
be inserted into an electrical outlet that is properly
installed and grounded according to all local codes
and ordinances.
If you must repair or replace the power cord or
plug, do not connect the grounding wire to either
flat-blade terminal. The wire with insulation having
an outer surface that is green (with or without
yellow stripes) is the grounding wire.
Check with a qualified electrician if you don’t
completely understand these grounding
instructions, or if you are not sure whether the
machine is properly grounded. Do not modify the
plug provided; if it won’t fit in the outlet, have a
proper outlet installed by a qualified electrician.
Disconnect the power cord before servicing,
cleaning, or removing any covers
Follow the lockout/tagout procedures of your
company.
Do not open the door until the machine comes
to a complete stop.
CAUTION!
Keep the work area free of clutter and electrical
cords.
Avoid extension cords. To minimize the risk of
improper electrical grounding, extension cords are
not recommended. If an extension cord is
unavoidable, consult a qualified electrician to
determine what type of extension cord will satisfy
the grounding, current capacity, and other
requirements of the particular situation.
Use the proper power source. Refer to the
machine data plate on the right side panel or the
section 2.1, Specifications, in this manual.
Keep customers away from the work area. The
machine should be used only by properly trained
individuals.
Clamp the can carefully to ensure that it is held
securely during the mixing cycle.
To avoid electric shock, don’t get the timer,
control panel, or wiring wet.
This machine is not explosion proof rated.
All containers must be properly sealed and void
of leaks.
Review product label, Material Safety Data
Sheet, and HMIS rating of materials prior to mixing
to determine potential hazards.
Do not use solvent-based cleaners or thinners.
Use in a dry and well-ventilated environment
where dust and flammable vapors are not present.
Product safety labels should be inspected and
cleaned periodically to maintain good legibility.
Replace any labels that are no longer legible.
