4. Now you need à set the decimal format. The numerical data
structure downloaded à the SD card is defaulted used the “.
” as the decimal, for example “20.6” “1000.53”. But in certain
countries the “ , ” is used as the decimal point, for example “20,6”
“1000,53”. See Advanced Settings section of this manual for
instructions on how à change the Decimal Character.
Auto Datalogger (Set sampling time ≥1 second)
1. Start Datalogging; press the REC Button, and the “REC” symbol
will appear on the LCD screen, then press the Logger Button, the
“REC” symbol will ash while the measuring data and time infor-
mation is being saved in memory. à set the sampling time, and à
toggle the beeper sound on or off, refer à the Advanced Settings
section of this manual.
2. Pause the Datalogging; while Datalogging, if press the Logger
Button once. While paused, the “REC” symbol will stop ashing.
Press the Logger Button again à resume Datalogging, and the
“REC” symbol will begin à ash again.
3. Stop Datalogging; while the Datalogger function is paused, press
the REC Button for 2 seconds. The “REC” symbol will disappear
indicating the Datalogging function has stopped.
Manual Datalogger (Set sampling time = 0 seconds)
1. Set sampling time is à 0 second; Press the REC Button, and the
“REC” symbol will appear on the LCD screen. Press the Logger
Button, and the “REC” symbol will ash once and one Beep will
sound, at the same time the measuring data along the time infor-
mation will be saved in memory. The lower Display will show the
Position (record) number, which is saved as well.
2. To Change the Position Number; press the Down Button and the
lower position number will ash on the display. Press the Up or
Down Buttons à set the Position Number (1 à 99) à help identify
the measurement location. The lower Display will show P x (x = 1
à 99). After the position number is selected, press the Enter But-
ton à conrm. continued...
