Rhino-Rack 43175 User manual

Maximum Lashing Capacity: 225kg/ 496Lbs per set.
Recommendations:
Use only non stretch fastening ropes or straps. Do not overload your Rhino-Rack Pioneer Platform/ Tray or Tradie Tray
and roof bars. Check your vehicle’s roof carrying capacity. Exercise caution when driving off road as vehicle roof height
has been increased. Be aware of increased sensitivity to cross winds.
- Regularly check strap condition for any signs of abrasion. Immediately replace. Do not use a strap that is damaged.
- Do not overload roof capacity. Always evenly distribute load.
- Remove load/ roof racks when putting vehicle through an automatic car wash.
Caution:
The handling characteristics of the vehicle change when you transport a load on the roof. For safety reasons, we
recommend exercising extreme care when transporting large wind-resisting loads; special consideration must be
taken into account when negotiating corners and under braking.
Note for Dealers and Fitters:
It is your responsibility to ensure instructions are given to the end user or client.
Rhino-Rack
3 Pike Street, Rydalmere,
NSW 2116, Australia. Document No: R728 Fit time: 15min
(Ph) [phone] Prepared By: Kayle Everett Issue No: 03
(Fax) [phone] Authorised By: Chris Murty Issue Date: 16/05/16
These instructions remain the property of RhinoRack Australia Pty. Ltd. and may not be used or changed for any other purpose than intended.
Important Information
Page 1 of 2
Pioneer Pickup Kit 43175
Important: Please read these instructions carefully prior to installation.
Please refer to your fitting instruction to ensure that the alloy tray is installed correctly.
Check the contents of this kit before commencing fitment and report any discrepancies.
CONTROLLED

1
2
3
4
Assemble the Pickup kit as shown. Do not tighten
hardware at this stage.
Slide the Pickup Moulding into the Pioneer access slot
as shown. If this proves difficult, slightly loosen the
hardware.
The longer
underside of the
Pickup Moulding
faces the outside
Platform.
Pick-Up Point
Pioneer Platform
Secure your load between two or more Pickup
Mouldings on the Pioneer Platform. Wrap the looped
ends of the Ratchet Strap sections over each Moulding
as shown.
Pull the strap through the Ratchet as shown. Tighten
over the load to be carried. Ensure load is secure before
driving.
Move lever up
and down to
tighten.
M6x10 Counter Sunk Screw
Pickup Moulding
M6 20x20 Square Nut
34
12
5 5
35mm
35mm
107mm
Item Component Qty Part No.
1 Security Allen Key 4mm 1 H048
2 M6x10mm Counter Sunk Screw 8 -
3 M6 20x20 Square Nut 8 N025
4 Pioneer Pickup Moulding 4 SP202
5 Ratchet Strap 1850mm 2 CA1448
6 Fitting Instructions 1 R728
Page 2 of 2
Pioneer Pickup Kit 43175
Repeat steps 1-2 for opposing side.