Rimage Producer III 8100 Manual

Producer III/Producer IIIN Maintenance Schedule
Maintain the Producer III Autoloader
This section provides information about preventative maintenance and how to align the printer.
,Warning! Always power off the autoloader and unplug the power cord before you access the embedded PC.
Overview
Regular preventative maintenance of your Producer III can help to ensure error-free recordings and clean printed
labels. Maintenance involves cleaning the system and aligning the printer on top of the autoloader.
Note: The printer has its own maintenance requirements. Refer to your printer’s User Guide for information.
Cautionary Information
nCaution: To avoid damaging the Producer III during maintenance:
•Never use oils, silicone, or other lubricants on any part of the Producer III.
•Use only non-abrasive cleaners to wipe down the surfaces of your Producer III.
•Never use cleaners to clean the embedded PC.
•Avoid pouring cleaners directly onto the Producer III. Instead, apply the cleaner to the cloth first.
•Observe precautions for electrostatic-sensitive devices whenever you access the embedded PC.
2000538_B 1

Maintain the Producer III Autoloader
2000538_B 2
Preventative Maintenance Schedule
Use the following table as a guideline for how often to perform preventative maintenance tasks.
Note: Your system may require more frequent maintenance if used in a dusty area, such as a store or
warehouse.
Before you begin:
1. Power off the Producer III.
2. Disconnect the power cord.
-Important! Failure to follow the maintenance schedule outlined below may void your warranty.
Tool Task Frequency
Align the printer
Refer to the procedures below for more
information.
Upon installation or if the discs are
not picked correctly from the printer
tray.
Lint-free cloth
Non-abrasive, all-
purpose cleaner
Wipe down the lead screw and pay
close attention to:
•the area just above the bearing at the
base of the lead screw
•the area just above the lift arm
Weekly
Lint-free cloth
Non-abrasive, all-
purpose cleaner
Wipe down all surfaces of the
autoloader, including:
•sides and top
•Input bins
•output trays
•output bin
•base (remove the input bin first)
•top surface on the lift arm
Weekly
Can of compressed air
Remove dust and debris from the fans
at the back of the autoloader.
Monthly
Vacuum
Remove dust and debris from the
openings at the back of the autoloader.
Monthly
Can of compressed air
Remove the side panels and remove all
dust from the embedded PC.
Monthly
Torx T25 driver
Align the printer. Refer to the Align the
Printer instructions in the Producer III/
Producer IIIN User Guide.
On installation and as needed.