ring Z-Wave User manual

1
Flood & Freeze Senso Z-Wave
Technical Manual

2
Ring Flood & Freeze Sensor
Instructions to locate Z-Wave DSK/QR code
Follow Device inclusion instructions provided in Ring Alarm mobile applications to locate QR code and
enter PIN Code
Factory Reset Instructions
Press and hold the Setup button for 10 seconds. When the LED ring stops blinking, Listener will reset.
This process disconnects the Listener from Ring Alarm. To begin using the Listener again, repeat the
setup process in the Ring app.
“Use this procedure only in the event that the network primary controller is missing or
otherwise inoperable.”

3
To review your warranty coverage, please visit www.ring.com/warranty.
© 2020 Ring LLC or its affiliates.
Ring, Always Home, and all related logos are trademarks of Ring LLC or its affiliates.
Association CC:
This sensor has one Association groups of 1 node. Group 1 is the lifeline group who will receive
unsolicited messages relating to Smoke/CO Siren detected/not detected notifications, case tampering
notifications, and low-battery notifications.
Parameter No. Description Number
of Bytes Default Minimum Maximum
1
Heartbeats:
This parameter is the number seconds
between heartbeats. Heartbeats are
automatic battery reports on a timer
after the last event.
24200
(0x1068) 255 (0xFF) 4200 (0x1068)
2
One shot timer:
Writing to this parameter prompts the
sensor to send a wakeup notification
one time after this parameter’s number of
seconds. After which it is reset back to 0.
2 0 1 32767
(0x7FFF)
3
Number of application level retries of
messages either not ACKed or messages
encapsulated via supervision get that
did not receive a report.
1 5 0 5