RiverRidge 02-146 User manual

RiverRidge®Kids Toy Organizer
with Cubbies and Veggie Bins
ITEM#: 02-146 White
ITEM#: 02-147 Gray
ASSEMBLY INSTRUCTIONS
ADULT ASSEMBLY REQUIRED
WARNING
SEE FULL WARNING ON PAGE 2
This product requires assembly by an adult because of small parts. Care should be taken
in unpacking and assembling this item to keep small parts away from children. During assembly
children should be kept away from the product due to possible risk of injury.
Young children can be seriously injured or killed if furniture tips over.
Don’t use this item for a TV stand or place heavy objects on top of item.
Always use angle-braces or anchors to secure furniture to the wall.

EACH CABINET WILL HOLD UP TO 20 POUNDS PER CUBBY, 30 POUNDS PER VEGGIE BIN
AND 25 POUNDS PER TOP SHELF OR A TOTAL OF 145 POUNDS. DO NOT LOAD EACH
CUBBY WITH MORE THAN 20 POUNDS, EACH VEGGIE BIN WITH MORE THAN 30 POUNDS
OR THE TOP SHELF WITH MORE THAN 25 POUNDS. IF OVERLOADED WITH MORE THAN
20 POUNDS PER CUBBY, 30 POUNDS PER VEGGIE BIN OR 25 POUNDS ON THE TOP
SHELF, THIS MAY CAUSE DAMAGE TO THE CABINET AND MAY CAUSE SERIOUS INJURY
OR DEATH.
This product is suitable for children 3 years and older.

1
6
5
8
8
9
10 3
4
PARTS LIST
NO QTY DESCRIPTION
1 1PC Top Board
2 1PC Left Side Panel
3 1PC Right Side Panel
4 1PC Middle Panel
5 1PC Bottom Board
6 1PC Large Shelf
7 2PCS Front Panel
8 2PCS
9 1PC
10 1PC
Small Back Board
Large Back Board
Small Shelf
7
7
2

TOOLS NEEDED FOR ASSEMBLY: FLAT & PHILLIPS SCREWDRIVER (NOT INCLUDED)
THE USE OF A POWER SCREWDRIVER IS NOT RECOMMENDED FOR ASSEMBLY
DO NOT USE ITEM IF ANY PARTS ARE MISSING OR DAMAGED
PARTS LIST
NO QTYPARTS DESCRIPTION
A26PCS Cam Bolt
B26PCS Cam Lock
C6PCS Wood Dowel
D
2PCS
E
G
Screw (4x10mm)
H2PCS
J
2PCS
K
6PCS
24PCS Screw (2.5x12mm)
Screw (4x35mm)
Screw (4x30mm)
2PCS
Plastic Anchor
Adjustable Anchor Bracket
To order replacement parts at no cost to you, email [email protected], call
1-(844)-223-5201 or order parts online at www.riverridgehome.com. Only valid in the United States.
If purchased outside of the United States, please contact retailer where purchased.

STEP 1
STEP 2
A
A
A
A
A
A
K
G
G
K
1. Screw 4 cam bolts (A) into cam bolt holes on left side panel (2) and tighten to left side
panel (2).
2. Screw 6 cam bolts (A) into cam bolt holes on right side panel (3) and tighten to right
side panel (3).
1. Insert 2 screws (K) through holes on adjustable anchor bracket (G), then tighten to top
board (1).
2. Screw 6 cam bolts (A) into cam bolt holes on top board (1) and tighten.
3. Screw 4 cam bolts (A) into cam bolt holes on middle panel (4) and tighten.
4. Screw 6 cam bolts (A) into cam bolt holes on the other side of middle panel (4) and tighten.
2
3
4
1
4