RiverRidge 06-023 User manual

ASSEMBLY INSTRUCTIONS
RiverRidge® Ellsworth Two Door Wall Cabinet
ITEM#: 06-023 White
ITEM#: 06-024 Espresso
ITEM#: 06-128 Taupe
ADULT ASSEMBLY REQUIRED
This product requires assembly by an adult because of small parts. Care should be taken
in unpacking and assembling this item to keep small parts away from children. During assembly
children should be kept away from the product due to possible risk of injury.
WARNING SEE FULL WARNING ON PAGE 2
Young children can be seriously injured or killed if furniture tips over. Don’t use
this item for a TV stand or place heavy objects on top of item. Always use
angle-braces or anchors to secure furniture to the wall.

THIS SHELF UNIT WILL HOLD UP TO 25 POUNDS PER SHELF OR A TOTAL OF 50 POUNDS.
DO NOT LOAD EACH SHELF WITH MORE THAN 25 POUNDS OR 50 POUNDS TOTAL
WEIGHT. OVERLOADING WITH MORE THAN 25 POUNDS PER SHELF OR 50 POUNDS
TOTAL WEIGHT MAY CAUSE THE SHELF TO FALL FROM THE WALL AND CAUSE
SERIOUS INJURY OR DEATH.

PARTS LIST
NO
QTY
DESCRIPTION
1
1PC
Top Board
2
1PC
Left Side Panel
3
1PC
Right Side Panel
4
1PC
Right Door
5
1PC
Left Door
6
1PC
Rear Top Cross Bar
7
1PC
Towel Bar
8
1PC
Shelf
9
1PC
Bottom Board
10
1PC
Lower Back Board
11
1PC
Top Back Board
12
1PC
Middle Back Board

PARTS LIST
TOOLS NEEDED FOR ASSEMBLY: FLAT & PHILLIPS SCREWDRIVER (NOT INCLUDED)
THE USE OF A POWER SCREWDRIVER IS NOT RECOMMENDED FOR ASSEMBLY
DO NOT USE ITEM IF ANY PARTS ARE MISSING OR DAMAGED
To order replacement parts at no cost to you, email [e-mail], call
1-(844)-223-5201 or order parts online at www.riverridgehome.com. Only valid in the United States.
If purchased outside of the United States, please contact retailer where purchased.
NO
PARTS
QTY
DESCRIPTION
A
10PCS
Cam Bolt
B
10PCS
Cam Lock
C
18PCS
Wood Dowel
D
4PCS
Metal Hinge
E
1PC
Magnet
F
2PCS
Magnet Plate
G
2PCS
Knob
H
2PCS
Machine Screw (4x18mm)
J
18PCS
Wood Screw (3x10mm)
K
2PCS
Screw (3x14mm)
M
24PCS
Back Board Screw (2.5x12mm)
N
2PCS
Long Screw (4x45mm)
O
2PCS
Plastic Anchor
1PC
Wall Mounting Paper Template

STEP 1
1. Screw 4 cam bolts (A) into cam bolt holes on top board (1).
2. Insert 2 wood dowels (C) into dowel holes on top board (1).
3. Attach magnet (E) to top board by inserting 2 screws (K) through holes on magnet (E) and
tighten to top board (1).
STEP 2
1. Screw 3 cam bolts (A) into cam bolt holes on left side panel (2).
2. Insert 7 wood dowels (C) into dowel holes on left side panel (2).
3. Attach 2 metal hinges (D) to left side panel (2) by inserting 4 wood screws (J) through
holes on metal hinges (D) and tighten to left side panel (2).