Salus SS881ZB User manual

ϭ
^hϮϭ
tŝƌĞůĞƐƐŽŽƌ^ĞŶƐŽƌ
Θ
^hϮϭ
tŝƌĞůĞƐƐtŝŶĚŽǁ^ĞŶƐŽƌ
YƵŝĐŬ/ŶƐƚĂůů'ƵŝĚĞ


Ϯ

ϯ
dĂďůĞŽĨŽŶƚĞŶƚƐ
ZĞĂĚƚŚŝƐďĞĨŽƌĞƵƐĞ .................................................................................................................... ϰ
^ƚĂƌƚ,ĞƌĞ..................................................................................................................................... ϱ
ϭ ^ĞƚƵƉƚŚĞ^ĞŶƐŽƌŝŶƚŽ ŝŐĞĞŶĞƚǁŽƌŬ ................................................................................ ϱ
ϭϭ >ŽŐŝŶƚŚĞŝŽŶƚƌŽů^ĞƌǀŝĐĞůŽƵĚ..................................................................................... ϱ
ϭϮ ^ƚĂƌƚƚŚĞƉƌŽĐĞƐƐŽĨĂĚĚŝŶŐĚĞǀŝĐĞ ................................................................................. ϱ
ϭϯ DĂŬĞ^ĞŶƐŽƌƉĂŝƌĞĚƚŽƚŚĞEĞƚǁŽƌŬ ............................................................................... ϴ
ϭϰ EĂŵĞƚŚĞ^ĞŶƐŽƌĂĨƚĞƌƐƵĐĐĞƐƐĨƵůƉĂŝƌŝŶŐ ...................................................................... ϴ
ϭϱ hƐŝŶŐŽĨƚŚĞtŝŶĚŽǁƐŽŽƌ^ĞŶƐŽƌ ............................................................................... ϵ
ϭϲ ƉƉĞŶĚŝdžŶŽƚĞƐŽĨƚŚĞŶĞƚǁŽƌŬƉĞƌĨŽƌŵĂŶĐĞ................................................................ ϵ
Ϯ^ƵƉƉŽƌƚĞĚŝŐĞĞůƵƐƚĞƌƐ ................................................................................................. ϭϬ

ϰ

ZĞĂĚƚŚŝƐďĞĨŽƌĞƵƐĞ
• ZĞĂĚƚŚĞƐĞŝŶƐƚƌƵĐƚŝŽŶƐĐĂƌĞĨƵůůLJďĞĨŽƌĞƵƐĞĂŶĚŬĞĞƉŝƚŝŶĂƐĂĨĞƉůĂĐĞĨŽƌĨƵƚƵƌĞ
ƌĞĨĞƌĞŶĐĞ
• &ŽƌŝŶĚŽŽƌƵƐĞŽŶůLJ
• ůůŵĂŶƵĂůƐĂĨĞƚLJŝŶƐƚƌƵĐƚŝŽŶƐĂŶĚĞůĞĐƚƌŝĐŝƚLJƐƵƉƉůŝĞƌƐƌĞŐƵůĂƚŝŽŶƐŵƵƐƚďĞĨŽůůŽǁĞĚ
KƚŚĞƌǁŝƐĞŝƚŵĂLJĐĂƵƐĞĂĐĐŝĚĞŶƚƐŽƌĚĂŵĂŐĞƚŚĞƉƌŽĚƵĐƚ
• ŽŶŽƚŝŶƐƚĂůůƚŚŝƐƵŶŝƚĂƚĂŶĂůƚŝƚƵĚĞŽĨŽǀĞƌϮϬϬϬŵĞƚƌĞƐ
• dŚĞtŝƌĞůĞƐƐŽŽƌ^ĞŶƐŽƌƐŚŽƵůĚŽŶůLJďĞƵƐĞĚŝŶĚƌLJĂŶĚĐůĞĂŶĞŶǀŝƌŽŶŵĞŶƚŽŶŽƚ
ƉůĂĐĞƚŚĞƵŶŝƚŝŶďĂƚŚƌŽŽŵŽƌŽƚŚĞƌĂƌĞĂǁŝƚŚĞdžĐĞƐƐŝǀĞŵŽŝƐƚƵƌĞ
• ŽŶŽƚĞdžƉŽƐĞƚŚĞƵŶŝƚƚŽƚĞŵƉĞƌĂƚƵƌĞƐďĞůŽǁͲϭϬΣŽƌĂďŽǀĞϰϬΣŚƵŵŝĚŝƚLJĂďŽǀĞ
ϵϱйŶŽŶͲĐŽŶĚĞŶƐĞĚ
• ůĞĂŶƚŚĞƵŶŝƚǁŝƚŚĂĚƌLJƐŽĨƚĐůŽƚŚŽŶŽƚƵƐĞƐŽůǀĞŶƚƐŽƌĂŐŐƌĞƐƐŝǀĞĐůĞĂŶŝŶŐĂŐĞŶƚƐ
• dŚŝƐĚĞǀŝĐĞŝƐĚĞƐŝŐŶĞĚĨŽƌŚŽƵƐĞŚŽůĚƵƐĂŐĞŽŶůLJŶŽƚƐƵŝƚĂďůĞĨŽƌĐŽŵŵĞƌĐŝĂůĂŶĚ
ŝŶĚƵƐƚƌŝĂůƵƐĞ
• ŶLJŵŽĚŝĨŝĐĂƚŝŽŶŽƌƵƐĞŽƚŚĞƌƚŚĂŶĚĞƐĐƌŝďĞĚŵĂLJĚĂŵĂŐĞƚŚĞƵŶŝƚĂŶĚǁŝůůǀŽŝĚƚŚĞ
ǁĂƌƌĂŶƚLJ
• dŚĞƌĞŝƐŶŽƐĞƌǀŝĐĞƉĂƌƚŝŶƐŝĚĞƚŚĞƉƌŽĚƵĐƚŝŶƐƚĂůůĂƚŝŽŶĂŶĚƌĞƉĂŝƌŝŶŐƐŚŽƵůĚďĞ
ƉĞƌĨŽƌŵĞĚŽŶůLJďLJĂƵƚŚŽƌŝnjĞĚƐĞƌǀŝĐĞĐĞŶƚƌĞŽƌƋƵĂůŝĨŝĞĚƉĞƌƐŽŶŶĞů
• KŶůLJƵƐĞŶĞǁďĂƚƚĞƌLJ

ϱ
^ƚĂƌƚ,ĞƌĞ
1. 
• Make sure the iControl-hub is powered up and connected to internet before device pairing.
• Prepare the Door/Window Sensor but do not power up them before getting ready on below steps.
ϭϭ 
• Access on the website: https://pdev.icontrol.com/sp/login.jsp
• Login the iControl system with the account (Name: kairylei Password: ll99 ).
ϭϮ ǣ
• Select “Settings”,and click on the “Door/Window Sensors”:

ϲ

ϳ
• Click on button “ADD DOOR/WINDOW SENSOR”
• Click on “NEXT”:
• iControl Server enters to Pairing mode.
• Till this step, the system gets ready for the Sensor joining to the network. It’s waiting for any sensor
to join its network. This waiting would be timed out after 5 minutes if there was no expected sensor
found to join it. Then you have to redo upper steps again.

ϴ
ϭ  
• Pulling out the insulation tape can energize the Door/Window SENSOR to scan netwrok and
subsequently paired to the network successfully. The sensor will take below rules for its joining:
(a). It will scan all channels every 5 seconds and will try to join any available network. For each
scanning, the LED will blink for 3 times.
(b). If no network found after 20 times of scan, the Sensor will stop the trying to join. (LED will be in
constant off state.)
(c). After stop of scanning,a single press on the tamper button or having a magnet triggering of the
sensor, or re-powering up of the sensor, can has the sensor resume the scanning state again.
ϭϰ ǣ
• Once paired successfully with below page, click on “CONTINUE WITH PAIRED DEVICE”; then
input the name,click”NEXT”.
• It’s done with adding of a sensor now.

ϵ
ϭϱ  Ȁǣ
On the “Home” page, you can see all of your devices. Within the “Sensor” group, your sensors
were listed there. For example, along with the Window sensor magnet part close/ apart, it will show
the Closed/Open state on the list immediately, also with a historical log for the changes on right
side.
ϭϲ ǣ
1) Redo a pairing for an already paired device:
a) A normal way of this is to remove the device from the “setting” page while the device is
online. If you did that with device offline, it would also take the leaving network process
once it’s back.
b) If your sensor was paired early to another iControl-hub, it would not take a pair process
automatically. You have to force it to leave the network and join again. You need to hold
the temper switch while the sensor was powering up by reinstalling the battery, the LED
will be lit and you shall release the switch within the first 4 seconds. The the sensor will
leave its past network and begin the pairing process as upper step 4.3, of cause, prior
with ready on the web page and the hub.
* With this operation, if the sensor was in fact in a same network early, the pairing will be
failed. You have to find out it from the device list and remove it and do that again.
2) Resume of the lost link state:
In case of lost link from network (can not find the parents node), the Sensor can try to rejoin the
network every 5 minutes, or by 5 times of press on the button, with less then 1.5 seconds for
each press.

ϭϬ
2. 
Paramater Function
Supporting profile HA 1.2 and above.
iControl compatible.
Supporting clusters Basic cluster
Identify cluster
Power configuration cluster
Poll control cluster
Temperature measurement cluster
Commissioning cluster
Diagnostics cluster
OTA cluster
IAS zone cluster
EZ-Mode
Binding Support Yes
)&&6WDWHPHQW

 













 





,&67$7(0(17









Canada's licence-exempt RSSs.
The distance between user and products should be no less than 20cm, La distance entre l'utilisateur et de produits ne devrait pas être inférieure à 20cm.
The distance between user and products should be no less than 20cm