Sanipex BAGNODESIGN BDM-SES-433-XX-XX User manual

BAGNODESIGN
  
Installation Guide
BDM-SES-433-XX-XX
SESTRIERE 5 HOLE BATH/SHOWER MIXER
 
Please leave these instructions with the customer

TECHNICAL SPECIFICATIONS
Minimum hydraulic pressure: 0,5 bar Maximum hydraulic
pressure: 10 bar Recommended working pressure: from 1 to 5
bar
Tested pressure: 16 bar
Temperature of inlet hot water: 80°C Suggested temperature
(Energy sa-ving): 60°C
Functioning automatic diverter:
≥ 0,5 bar (dynamic pressure)
It is very important that hot and cold water temperature will
be balanced as much as possible to grant the optimum
performance of the single-lever mixer.
If pressure is higher than 5 bar it is advi-sable to install a water
pressure reducer. The employ of these mixers with low
pressure hot water accumulators is not suitable.
1
IT IS COMPULSORY TO CREATE AN INSPECTION AREA
FOR ANY FUTURE MAINTENANCE OF THE MIXER.

DRILLING SCHEME FOR DECK MOUNTED TRADITIONAL BATH TAP
DRILLING SCHEME FOR DECK MOUNTED TRADITIONAL BATH TAP
2

CONTROL
Place the upright by
screwing the lock-nut the
washer and the
gasket to adjust the
locking according to the
bathtub thickness.
Screw the same parts in
the upper side of the
bathtub, then place the
washer , screw the cap
onto the upright body
then fit the han-dle.
Secure with the screw and
insert the plate.
3

DIVERTER
Screw onto the diverter
body the lock-nut the
washer and the gasket.
Adjust the locking
according to the bathtub
thickness, then fit the
diverter body upwards
inside the bathtub hole.
Insert the cap with its OR
and the knob. Now it is
possible to register
properly the cup by
screwing or unscrewing it
not to see the
rod inside the diverter
anymore.
After this stage secure the
set by locking the lock-nut
at the bottom side of the
bath plan.
4

HAND SHOWER
Fit the shower holder and
fix with the lock-
nut ,connect the fle-xible
hose and screw the hand
shower.
5
Flow reducer

FILLER SPOUT
Place the filler set by
fitting the washer with its
OR, then secure with the
lock-nut the lock-washer
and the gasket.
6

Use soft cloth, soapy solution and water for regular care.Wipe
with a dry cloth.
Avoid the use of abrasives or solvents, which damage the
surface. Damage caused by inappropriate treatment by the
user, is not covered by our guarantee.
CLEANING
7

Note:

Note:

INM-SES-433-X-XX-02-21 D766B20156