Schlage CO-Series User manual

CO-Series with Mortice
Installation Instructions
ToolsIncluded
Right Hand Shown, Left Hand Opposite
2
1
1Prepare Door
See template.
IfInsulator Strip isPresent,CarefullyRemoveit
Inside
Outside
!
Please refer to Legge 990 Mortice instructions for
installation of the mortice lock

3
4
Check Lever Handing
See "Rehanding" on back page if pin is not towards
latch
Install Cylinder and Lever
b
c90˚
RH
90˚
LH
OR
Until Cam Stops
a
Align asShown
a
b
c
Keyed Lever Interchangeable Cores
OR
d
e
f
d
e
15°
f

7
8
!
Outside
x1
AlignTriangles
a
x4
x4
Wrench
"
6
5
Slide Mortice Lock Into Door
9Install Bushing and Outside Escutcheon
a
a
b
Prepare Legge 990 Mortice Lock for installation.
Please refer to Legge 990 Mortice Lock installation guide
for more details (in lock box).
Install Outside Spindle and Standoffs

10 Install Plate and Spindle
11
b
a
TOP
14
13
12
Inside
Align as Shown
Inside
a
x2
b
x2
x2
x2
b
a
x2
x2
or
For door thickness
>42mm
For door thickness
35mm - 42mm

15
16 Test Mechanical Function
a.Rotate lever down and verify that latch retracts fully
17 RouteWires and Install Inside Escutcheon
b.
OR
Release lever and verify that latch extends fully
x2
a
b
c
x2
a
b
c
40 / 50
Ribbon Cable
70
Battery Cable
Classroom/Storeroom (70) Function
Office (40) or Privacy (50) Functions

BTuck Cable and Wires as Shown
!Plug MUST Be on Right
Install Battery Holder and Strap
IMPORTANT - when installing the battery pack, the plug for
the pack must be on the right.
b
a
20 Connect Battery Plug and Tuck as Shown
19
Cable
18
A
!Red Wire MUST Be On Left
Install Ribbon Cable
IMPORTANT - the red wire must be on the left.
Follow Steps Below if 40 or 50 Function Only
If 70 Function, Go to Step 22

x2
Cap Pin (2 Positions)
2 Notches from Full
Classic
Everest or Primus
Future Lever Removal
Changing the Cylinder’sTailpiece
Install Strike
Setup and Operation.
After Installing the Lock, See the User Guide for
#16
#12-24
Wood
Metal
Prepare Frame
d
a
b
a
b
c
21
22
23
24

Rehanding
RHR
LHR
b.
c.
Remove Reader and Cover From Baseplate
d.
Remove Spring Cage, Align Arrow with Latch, and Reinstall
Reinstall Cover and Reader onto Baseplate
!
!
a. If Present, Remove USB plug
!
Use Loctite
NOTE: On Keypad Only Applications, Reader is Not
Removable!
Allegion (New Zealand) Limited
Phone [phone]
Website www.allegion.co.nz
Allegion (Australia) Pty Ltd
Phone [phone]
Website www.allegion.com.au 12/2013