Schlage S-260 User manual

Right door handle shown.
Product installation
Template for single door jamb preparation.
Installation template
Mark 3 hole locations including magnet
location. (Check handing)
After confirming the drill location matches
the location of the product, drill using a
13mm drill bit.
Insert battery and check if it operates by
pressing [Lock/Unlock] button.
Double door or frameless glass, use
optional strike (S-260H).
1
3
2
4
Right direction door
Left direction door
Magnet hole 13mm
Dead bolt hole
13mm
Match the sensor position of the product to the magnet position in door jump.
Slide the main body fully against the two
protruding parts and the two fixed plates.
How to install the fixture plate
When left/right direction is not converted.
Step 1
180
Right
direction
door
L
R
Manual
adjust
lever
Left
direction
door
Please use adjustment lever if the keypad
doesn’t automatically adjust.
Inside
Remove the double sided tape
protection film on the back of the
fixture plate.
Attach the fixture plate to the interior
of the glass door.
2
1
Fixture
Plate
Hook
Inside
Step 2
Keypad will adjust automatically to
handing of door.
Step 3
Left Hand Internal
S-260 Digital Glass Door Lock

The cord is fitted by default.
See below when reinstalling.
Disassemble the back and
attach it to the connection
area.
Remove adhesive protection and
attach the steel pad to the side
of the product.
Remove Thumb-turn from the
product.
Installation Considerations
• Glass door gap : 2.5mm~5mm
• 2-door glass door upper and
lower deviation : within 2.5mm
2-door glass door before and
after deviation : within 2.5mm
• If doors are severely slanted,
horizontal glass door and
before/after should be
within 2mm.
• If the gap of glass door is
bent out of shape, automatic
locking may be difficult or fail.
(Proceed with caution)
1
2
3
Thumb-turn Steel pad
Dead bolt for safety glass doors
For details regarding
product and installing
method, please refer
to the website.
※ It is recommended to install
without the safety glass rubber.
RH Single
12
Right door handing shown.
Left/Right direction changing method
RH Double (w/S-260H) LH Single
12
LH Double (w/S-260H)
Remove thumb-turn and attach it
to steel pad when going out,
and open and close the door to
activate the outing mode .
How to install thumbturn cord How to install a steel pad
Australia
Phone: [phone]
Email: [email protected]om
www.allegion.com.au
South East Asia
Phone: [phone]
Email: [e-mail]
www.allegion.com
New Zealand
Phone [phone]
Email [email protected]om
www.allegion.co.nz
Middle East, India & Africa
Phone [phone]
Email [e-mail]
www.allegion.com/mea