Sealey VS0216 User manual

BRAKE DISC LIP REMOVER SET
MODEL NO: VS0216
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,
and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING! Ensure all Health and Safety, local authority, and general workshop practice regulations are strictly adhered to when using
tools.
8DO NOT use tools if damaged or worn.
9Maintain the tools in good and clean condition for best and safest performance.
9Ensure that a vehicle which is jacked up is adequately supported with axle stands, ramps, etc. as appropriate.
9Wear suitable clothing to avoid snagging. DO NOT wear jewellery. Tie back long hair.
9Wear approved hand and eye protection and face mask. A full range of personal safety equipment is available from your Sealey stockist.
9Account for all tools and parts being used and do not leave them in or on the vehicle.
9When not in use, store in a safe, dry and child-proof location.
WARNING! The warnings, cautions and instructions discussed in this document cannot cover all possible conditions and situations that
occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must be applied by
the operator.
IMPORTANT: Always refer to the vehicle manufacturer’s service
instructions, or proprietary manual, to establish the correct
procedure and data. These instructions for use are provided
as a guide only.
2. INTRODUCTION
Designed to remove the lip and corrosion that can form on the brake disc.
The handle bolts to the hub and provides a smooth easy method
 ofspinningthediscfore󰀨ortlesslipandcorrosionremoval.Theset
consists of crank handle, scraper and steel blades x2.
3. OPERATION
NOTE: Ensure you read and understand safety section above.
3.1. With the road wheel removed and the vehicle securely and safely raised,
 xthecrankhandletothewheelhubusingtheoriginalxings(either
bolts or nuts).
3.2. To load the blade, unscrew the blade clamp from the handle and loosen
 itsu󰀩cientlytoslidethebladein.Firmlyretightentheclampontoblade.
3.3. Brace the blade on the calliper, rotate the wheel using the crank handle while pressing the blade onto the disc lip or rim.
VS0216 Issue 1 21/09/22
Original Language Version
© Jack Sealey Limited
Refer to
instruction
manual
Wear protective
gloves
Wear eye
protection
Wear face
mask
Blade
Clamp
Blade
Crank
Handle

ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceableandrequiresdisposal,drainanyfluids(ifapplicable)intoapprovedcontainersanddisposeoftheproductandfluids
according to local regulations.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 [e-mail] www.sealey.co.uk
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts
without prior notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
REGISTER YOUR
PURCHASE HERE